User manual PIONEER SE-CL621TV

[. . . ] Always observe safe driving rules and follow all existing traffic regulations. € This manual explains how to install this DVD Navigation Unit in your vehicle. Operation of this DVD Navigation Unit is explained in the separate “Operation Manual” that also came with this unit. 14 - Installation notes - Parts supplied - CAUTION - If you install with the left and right sides of the DVD Navigation Unit parallel to your vehicle’s forward / backward direction DIN Front/Rear-mount . [. . . ] Note: The position of the handbrake switch depends on the vehicle model. The mobile navigation system is connected here to detect the distance the vehicle travels. Always connect the vehicle’s speed detection circuit or the ND-PG1 speed pulse generator, sold separately. Failure to make this connection will increase errors in the location display. wARNING: IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE OR INJURY INCLUDING ELECRICAL SHOCK , AND INTERFERENCE WITH THE OPERATION OF THE VEHICLE’S ANTILOCK BRAKING SYSTEM , AUTOMATIC TRANSMISSION AND SPEEDMETER INDICATION. This lead must be connected to the power supply side of the handbrake switch. If this connection is made incorrectly or omitted, certain functions of your navigation system will be unusable. Ground side Handbrake switch 9 ENG/MASTER 96 10 CRD3647A_inst_001_029_UK 4/15/02 2:03 PM Page 11 ENGLISH This product Note: Cords for this product and those for other products may be different colours even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. power cord Black , Orange/white , Red , Yellow ESPAÑOL ☞ See Page 11. DEUTSCH Yellow/black When combining this navigation unit with a Pioneer car stereo, if the car stereo has yellow/black leads, connect them to those leads. Vibration may damage wires, leading to a short circuit or other damage to the vehicle. € To ensure proper installation, use the supplied parts in the manner specified. If any parts other than the supplied ones are used, they may damage internal parts of the unit or they may work loose and the unit may become detached. Choose a position where the main unit can be firmly installed, and install it securely. If the main unit is not securely fastened, the errors in location display will be greater. € Do not install the main unit on the board covering the spare tyre or other places which are subject to vibration. € When the main unit is installed under a front seat, ensure that it does not obstruct the sliding action of the seat. Strong mechanical shock to the main unit would increase the errors in location display. € Avoid installing the main unit in places where it will interfere with loading and unloading of the spare tyre, jack, tools, etc. € Check that a disc or a PC card can be ejected with the main unit installed. € Install the main unit on a surface within +30 degrees to -15 degrees tolerance (within five degrees to the left or right of your vehicle’s direction of travel). [. . . ] ) GPS aerial When routing the lead in from the top of the door Make a U-shaped loop in the lead on the outside to prevent rainwater from flowing along the lead into the interior of the vehicle. Clamps Use clamps to secure the lead where necessary inside the vehicle. When routing the lead in from inside the boot Waterproof pad Make sure the waterproof pad contacts the top of the rubber packing. Clamps Use clamps to secure the lead where necessary inside the vehicle. [. . . ]