User manual PIONEER SE-CL501T

[. . . ] € Disconnect the negative terminal of the battery before installation. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. € Place all cables away from moving parts, such as gear shift and seat rails. € Place all cables away from hot places, such as near the heater outlet. [. . . ] € Do not pass the yellow cable through a hole into the engine compartment to connect to a battery. € Never cut the insulation of the power cable of this unit in order to share the power to other equipment. € Control signal is output through blue/white cable when this unit is powered on. Connect it to an external power amp’s system remote control or the vehicle’s auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. € Never connect blue/white cable to external power amp’s power terminal. This cable and other product’s ground cable (especially, high-current products such as power amp) must be wired separately. Otherwise, fire or malfunction may result if they are accidentally detached. STAR STAR T T 3 Connecting the units Parts supplied Parts marked (*) are pre-installed. ) Binding screw* Rubber bush Double-ended screw Touch panel pen 4 Connecting the units Connecting the system English USB cable Connect to sparately sold USB device. 5 m This product 20 cm Multi-CD player (sold separately) iPod with Dock connector Wired remote input Hard-wired remote control adaptor can be connected (sold separately). It is necessary to set CAMERA POLARITY properly in SYSTEM MENU when connecting the rear view camera. 9 Connecting the units When connecting with a multi-channel processor Blue Black Black IP-BUS cable (supplied with DVD player) DVD player (e. , XDV-P6) (sold separately) Black Black Optical cable (sold separately) RCA cable (supplied with DVD player) Black Optical cable (supplied with multi-channel processor) Blue IP-BUS input (Blue) Optical output (Black) Blue RCA cable (supplied with multi-channel processor) This product To RL To RR Multi-channel processor (e. , DEQ-P6600) (sold separately) Multi-CD player (sold separately) Black Blue IP-BUS cable IP-BUS cable (supplied with multi-channel processor) When you connect a separately sold DVD player to the separetely sold multi-channel processor, the optical cable from DVD player must be connected to the optical cable 2 input (OPT. 10 Connecting the units When connecting the external video component and the display Display with RCA input jacks (sold separately) English To video input RCA cables (sold separately) Video input Rear monitor output To video output Audio input This product To audio outputs External video component (sold separately) • It is necessary to set AV INPUT to VIDEO in SYSTEM MENU when connecting the external video component. € It is necessary to set AV INPUT to S-DVD in SYSTEM MENU when connecting a multi-DVD player. When using a display connected to rear video output This product’s rear video output is for connection of a display to enable passengers in the rear seats to watch the DVD or Video CD. WARNING NEVER install the display in a location that enables the Driver to watch the DVD or Video CD while driving. € Consult with your dealer if installation requires drilling of holes or other modifications of the vehicle. € Do not install this unit where: — it may interfere with operation of the vehicle. € Do not install the display where it may (i) obstruct the driver’s vision, (ii) impair the performance of any of the vehicle’s operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver’s ability to safely operate the vehicle. [. . . ] € Do not install the display where it may (i) obstruct the driver’s vision, (ii) impair the performance of any of the vehicle’s operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver’s ability to safely operate the vehicle. Install this unit away from hot places such as near the heater outlet. € Optimum performance is obtained when the unit is installed at an angle of less than 30°. After inserting the holder into the dashboard, select and bend the tabs appropriate to the thickness of the dashboard material. [. . . ]