User manual PIONEER SE-A611

[. . . ] € Use of this unit in conditions other than the following could result in fire or malfunction. € To prevent short-circuit, overheating or malfunction, be sure to follow the directions below. € Disconnect the negative terminal of the battery before installation. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. [. . . ] € In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply, they must be obeyed and this unit’s DVD features should not be used. OF OF F O N F O N To rear output STAR STAR To front output Subwoofer output This product (AVHP4200DVD To subwoofer only) output Blue/white Connect to system control terminal of the power amp (max. The pin position of the ISO connector will differ depending on the type of vehicle. €When you connect the separately sold multi-channel processor (DEQ-P6600) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). €When you connect the multi-channel processor to this unit, refer to multi-channel processor’s installation manual for the connection method. Left Right  Subwoofer    Subwoofer  Front speaker   Rear speaker     Rear speaker Front speaker Perform these connections when using the optional amplifier. π Connecting the units Connecting the power cord Navigation unit can be connected (AVIC-F220 (sold separately)). Please contact your dealer to inquire about the connectable navigation unit. Note: Depending on the kind of vehicle, the function of 2* and 4* may be different. Microphone input (AVH-P3200BT) 4m 26 pin cable (Supplied with Navigation unit) Insert the 26 pin cable in the direction indicated in the figure. € The rear view camera function is to be used as an aid for backing into a tight parking spot. € Objects in the rear view may appear closer or more distant than they actually are. To video output Rear view camera (sold separately) RCA cable (sold separately) To SWR Optical output Wired remote input Hard-wired remote control adaptor can be connected (sold separately). (SE-A611 only) Installing the optical cable connection box • When installing the optical cable connection box with the hook and loop fastener. Install the optical cable connection box using the hook and loop fastener in the ample space of the console box. Rear monitor output (V OUT) Video input (V IN) Rear audio output (REAR AUDIO OUT) To video input To audio input Blue Black CAUTION IP-BUS cable (Supplied with Bluetooth adapter) Black Optical cable connection box (supplied with multi-channel processor) • Install this unit using only the parts supplied with this unit. If other parts are used, this unit may be damaged or could dismount itself, which leads to an accident or other problems. € Do not install this unit near the doors where rainwater is likely to be spilled on the unit. RCA cables (sold separately) Mini pin plug cable (sold separately) To video output Hook fastener Loop fastener Connecting the optical cable RCA cable (supplied with multi-channel processor) Blue Optical cable (supplied with multi-channel processor) This product (SE-A611 only) Fuse resistor Violet/white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards. Connect the optical cable so that it does not protrude from the main unit, as shown in the illustration. [. . . ] When using a display connected to rear video output This product’s rear video output and rear audio output are for connection of a display to enable passengers in the rear seats to watch the DVD, etc. Fasten with the lock tie WARNING Never install the display in a location where it is visible to the driver while driving. installation Note • Check all connections and systems before final installation. € Consult your dealer if installation requires drilling of holes or other modifications to the vehicle. [. . . ]