User manual PIONEER SA-8800

[. . . ] This product features a wide-angle lens, so the near view is wide and the far view is narrow, which may create a false sense of distance. Do not wash your car with an automatic car wash or high-pressure water as it may result in water entering the camera or the camera falling off. ­ If the rear view camera comes loose while you are driving it may cause an accident. Rear view camera × 1 RCA power supply cable × 1 Power supply unit × 1 Hexagon wrench × 1 Velcro tape (soft type) × 1 Velcro tape (hard type) × 1 Clamp × 10 Waterproof pad × 1 Double-sided tape × 1 Camera stand bracket × 1 Before making a final installation of the unit, temporarily connect the wiring to confirm that the connections are correct and the system works properly. [. . . ] When mounting this unit, make sure none of the leads are trapped between this unit and the surrounding metalwork or fittings. To prevent electric shock, do not install the power supply unit in places where it might come in contact with liquids. Do not mount this unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it. Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electrical wiring or other important parts. If this unit is installed in the passenger compartment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident. If this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mechanism and cause a short circuit. Adjust the angle of the rear view camera, and install so that the camera doesn't touch the car. When sticking to a glass surface, stick it on in a position that assures the camera doesn't touch the rear window. When humidity is high, dry the surface to which the unit is to be attached before installing. Power supply unit Rear view camera connector Rear view camera Power supply unit Product with a video input jack (Hideaway unit etc. This unit is for vehicles with a 12-volt battery and negative grounding. To avoid shorts in the electrical system, be sure to disconnect the battery cable before beginning installation. Refer to the owner's manual for details on connecting the other units, then make connections correctly. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. When replacing the fuse, be sure to only use a fuse of the rating prescribed on the fuse holder. To minimize noise locate the TV antenna cable, radio antenna cable and RCA power supply cable as far away from each other as possible. [. . . ] If this unit is installed in a vehicle that does not have an ACC (accessory) position on the ignition switch, the red lead of the unit should be connected to a terminal coupled with ignition switch ON/OFF operations. If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. 70 (W) × 23 (H) × 35 (D) mm 2-3/4 (W) × 7/8 (H) × 1-3/8 (D) in. Pull out from here Clamps Rear view camera RCA power supply cable Product with a video input jack (Hideaway unit etc. [. . . ]