User manual PIONEER S-W90S

[. . . ] The equipment should be disconnected by removing the mains plug from the wall socket when left unused for a long period of time (for example, when on D3-4-2-2-1a_A_En vacation). CAUTION The POWER switch on this unit will not completely shut off all power from the AC outlet. Since the power cord serves as the main disconnect device for the unit, you will need to unplug it from the AC outlet to shut down all power. Therefore, make sure the unit has been installed so that the power cord can be easily unplugged from the AC outlet in case of an accident. [. . . ] Do not place the unit near stoves or other heating equipment or at locations exposed to direct sunlight, as these can have an adverse effect on the cabinet and internal components. Also, do not install the unit where there is too much dust or high humidity, as these can cause malfunctioning or breakdowns. (Avoid cooking tables and other locations where the unit would be exposed to heat, steam and soot. ) ÷ Do not place heavy objects such as a television or TV monitor on top of the unit. Keep the unit away from devices such as cassette decks which are sensitive to magnetic fields. However, depending on the installation location, color distortion may occur if the speaker system is installed extremely close to the screen of a television set. If this happens, turn off the power switch of the television set, and turn it on after 15 to 30 minutes. If the problem persists, place the speaker system away from the television set. Please install this unit away from the antenna cable of the tuner, as noise can be caused with installation close to the antenna cable. In such a case, use this unit at a position away from the antenna and the antenna cable, or when playback of extra bass is not required, switch off the power for this unit. When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 60 cm at top, 10 cm at rear, and 30 cm at each side). Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the product, and to protect it from overheating. To prevent fire hazard, the openings should never be blocked or covered with items (such as newspapers, table-cloths, curtains) or by operating the D3-4-2-1-7b_A_En equipment on thick carpet or a bed. When the surfaces are very dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Never use thinners, benzine, insecticide sprays and other chemicals on or near this unit, since these will corrode the surfaces. When pressed, power is turned ON; when pressed again, power is turned OFF. With this unit, the bass level can be independently set, so do not turn up the bass on the stereo amplifier. When depressed (_ 180°), the output phase becomes the reverse of the input signal, and when raised (-- 0° ), it is in the same phase as the input signal. But when the sound connection between the subwoofer and the left and right speakers sounds unnatural, try switching to 180° and set the switch in the position where the sound is natural. Before making or changing the connections, switch off the power switch and disconnect the power cord from the AC outlet. This connection is for a stereo amplifier or receiver equipped with a SUBWOOFER PRE-OUT terminal. Connect to the LINE LEVEL INPUT terminal on this unit, using the specially provided RCA plug cord. [. . . ] I annat fall kan högtalaren falla ner från TV:n till följd av yttre stötar från t ex jordbävningar, vilket kan leda till att människor i närheten såväl som högtalaren skadas. VARNING: Springor och öppningar i apparatkåpan är till för att ventilera och säkerställa en tillförlitlig funktion av denna produkt och för att skydda den från överhettning och undvika risk för brand. Slå i så fall av strömmen till TV:n och slå den sedan på igen efter 15 till 30 minuter. Om enhetens strömförsörjning inte kan kopplas till förstärkaren eller mottagaren bör du slå på strömmen till förstärkaren/mottagaren innan du slår på strömmen till denna enhet. [. . . ]