User manual PIONEER RMX-1000

[. . . ] Com/support/ The Pioneer website shown above offers FAQs, information on software and various other types of information and services to allow you to use your product in greater comfort. Operating Instructions Mode d’emploi Bedienungsanleitung Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. [. . . ] The sound of the [X-PAD FX] button that was pressed is deleted from the recorded sound. 1 Insert the SD memory card on which the sampled sound sources are stored into the SD memory card slot of this unit. When the [BANK] button is pressed, the [BANK] indicators flash for the BANKs at which sampled sound sources can be loaded. En 13 RELEASE FX section 1 FX SETTING section 1 2 3 1 SETTING selector switch This switches this unit’s effect parameter data between the [DEFAULT] and [USER] modes. €” [DEFAULT] mode: This unit can be used with the default parameter data set upon shipment from the factory. €” [USER] mode: Parameter data created using remixbox can be loaded into this unit and used. 1 RELEASE FX selector switch This switches the type of RELEASE FX effect. What you can do using remixbox By using the “remixbox” application included with this unit, you can change the settings shown below. Effect parameters: The parameters of the different effects can be customized. Types of effects: The effect assigned to the [ROLL] in the X-PAD FX section can be changed to a different effect. Button sensitivity: The sensitivity of the [SCENE FX] and [ISOLATE FX] buttons can be adjusted. Management of sampled sound sources: Sampled sound sources loadable into this unit can be saved and managed. For instructions on installing remixbox, see Using remixbox on page 19. Using the RELEASE FX function 1 Switch the [RELEASE FX] selector switch. For details on the types of effects, see Types of RELEASE FX effects on page 17. The selected effect is applied to the sound selected in the FX SOURCE section. When the lever is moved back to its original position, the effect turns off. Any SCENE FX, ISOLATE FX or X-PAD FX effects that were on before are also turned off. Upon shipment from the factory, the same parameter data as for the [DEFAULT] mode is set for the [USER] mode. FX SOURCE section 1  Writing the customized parameter data from remixbox into this unit 1 Connect the computer on which remixbox is installed to this unit by USB cable.  Loading customized parameter data stored on an SD memory card 1 Store the customized parameter data on the SD memory card using remixbox. 2 Insert the SD memory card used in step 1 into this unit’s SD memory card slot. [. . . ] Is the audio level output from the [OUTPUT] terminals appropriately set?Tempo (BPM) cannot be measured or Is the audio input level too high or too low?Value of the measured tempo (BPM) differs from value recorded on CD, or tempo (BPM) values displayed on DJ player, DJ mixer, DJ software and this unit differ. This unit is not recognized after it has been connected to a computer. [. . . ]