User manual PIONEER RG-1

[. . . ] When disposing of used batteries, comply with governmental regulations or environmental public institutions' rules that apply in your country/area. Remove any cables and devices attached to this unit before detaching the front panel to avoid damage to the device or vehicle interior. Removing the front panel to protect your unit from theft 1 Press detach to release the front panel. 3 Put the front panel into the provided protective case for safe keeping. [. . . ] Important If you are using this unit in North, Central or South America, reset the AM tuning step (refer to AM (AM tuning step) on page 8). Playing a CD/CD-R/CD-RW 1 Insert the disc, label side up, into the disc loading slot. When playing back VBR (variable bit rate)-recorded MP3 files, VBR is displayed instead of bit rate value. After selecting, perform the following procedures to set the function. DSC ­ Repeat all tracks TRK ­ Repeat the current track FLD ­ Repeat the current folder RDM (random play) 1 Press a or b to turn random play on or off. If you turn random play on during folder repeat, FRDM appears in the display. SCAN (scan play) Scan play searches for a song within the selected repeat range. If the display has automatically returned to the playback display, select SCAN again by pressing F (function). After scanning of a disc (folder) is finished, normal playback of the tracks begins. Note When playing compressed audio, there is no sound during fast forward or reverse. Incompatible text stored with the audio file may not be displayed or may be displayed incorrectly. -- Never cut the insulation of the power cable of this unit in order to share the power with other devices. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle's auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Use speakers over 50 W (output value) and between 4 W to 8 W (impedance value). When installing this unit or power amp (sold separately), make sure to connect the ground wire first. Ensure that the ground wire is properly connected to metal parts of the car's body. The ground wire of the power amp and the one of this unit or any other device must be connected to the car separately with different screws. If the screw for the ground wire loosens or falls out, it could result in fire, generation of smoke or malfunction. Metal parts of car's body When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. [. . . ] You are using a device, such as a cell phone, that transmits electromagnetic waves near the unit. All the files on the inserted disc are embedded with DRM The inserted disc Replace disc. Move electrical devices that may be causing the interference away from the unit. When you contact your dealer or your nearest Pioneer Service Center, be sure to note the error message. [. . . ]