User manual PIONEER PL-111Z

[. . . ] CAUTION This product is a class 1 laser product classified under the Safety of laser products, IEC 60825-1:2007, and contains a class 1M laser module. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. Failure to connect the red lead (ACC) of this unit to a terminal coupled with ignition switch on/off operations may lead to battery drain. Remember that if the feature demo continues operating when the car engine is turned off, it may drain battery power. [. . . ] After selecting, perform the following procedures to set the function. Selecting a repeat play range to cycle between the following: 1 Press 6/ CD/CD-R/CD-RW !FOLDER ­ Repeat the current folder Playing tracks in random order to turn random play on or off. 1 Press 5/ Tracks in a selected repeat range are played in random order. After selecting, perform the following procedures to set the audio function. Depending on the version of iTunes used to write MP3 files to a disc or media file types, incompatible text stored within an audio file may be displayed incorrectly. The cut-off frequency and output level can be adjusted when the subwoofer output is on. Only frequencies lower than those in the selected range are outputted from the subwoofer. To cycle between the cut-off frequency and output level of the subwoofer. Cut-off frequency: 50HZ--63HZ--80HZ--100HZ --125HZ Output level: -24 to +6 SLA (source level adjustment) SLA (Source Level Adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. oN ­ When USB storage device is connected , depending on the type of device , the source is automatically switched to USB when you turn on the engine. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Ground cables for this unit and other equipment (especially, high-current products such as power amps) must be wired separately. If they are not, an accidental detachment may result in a fire or malfunction. If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. D Speaker leads White: Front left + White/black: Front left * Gray: Front right + Gray/black: Front right * Green: Rear left + or subwoofer + Green/black: Rear left * or subwoofer * Violet: Rear right + or subwoofer + Violet/black: Rear right * or subwoofer * e ISO connector In some vehicles, the ISO connector may be divided into two. When using a subwoofer of 70 W (2 ), be sure to connect the subwoofer to the violet and violet/black leads of this unit. Use of this unit in conditions other than the following could result in fire or malfunction. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. -- Place all cables away from moving parts, such as the gear shift and seat rails. [. . . ] To prevent this, we recommend you refrain from using DualDisc with this unit. Please refer to the information from the disc manufacturer for more detailed information about DualDiscs. Only the first 32 characters can be displayed as a file name (including the file extension) or a folder name. Russian text to be displayed on this unit should be encoded with the following character sets: ! [. . . ]