User manual PIONEER PDP-R06FE

[. . . ] This equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/ EEC. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. The wires in this mains lead are coloured in accordance with the following code: Green and Yellow : Earth Blue : Neutral Brown : Live If the plug provided is unsuitable for your socket outlets, the plug must be cut off and a suitable plug fitted. The cut-off plug should be disposed of and must not be inserted into any 13 amp socket as this can result in electric shock. [. . . ] Improper use of batteries can result in chemical leakage or explosion. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries. The batteries supplied with this product may have a shorter life expectancy due to storage conditions. If you will not use the remote control unit for an extended period of time, remove the batteries from it. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with a standard DIN45325 plug (IEC169-2), plug it into the antenna terminal at the rear of the Media Receiver. To help prevent noise, attach the supplied ferrite core to the connector end of the power cord as shown. Use the supplied cable tie to prevent the ferrite core from slipping on the cable. To power outlet UK and Eire AC power cord Disconnect the power cord from the power outlet, Plasma Display and Media Receiver when the system is not going to be used for a long period of time. Unless you set up TV channels that you can watch under the current conditions, you cannot tune in those channels. Turning on/ off the power When the Media Receiver is plugged into a power outlet, it is placed into the standby mode; the STANDBY indicator on its front panel should flash red. The Media Receiver stays in the standby mode unless it is unplugged from the power outlet. To turn off the system, press a on the remote control unit or STANDBY/ON on the Media Receiver. The Plasma Display and Media Receiver are placed into the standby mode; their respective STANDBY/ON indicators light up in red. You can then turn on the system again by pressing a or 0 to 9 on the remote control unit or STANDBY/ON on the Media Receiver. If you press 0 on the remote control unit, images come from the INPUT 1 source. You can also press POWER on the Plasma Display to turn off the system. However, you cannot then turn on the system again by pressing the buttons on the remote control unit and Media Receiver. If you are not going to use the Plasma Display System for a long period of time, be sure to remove the power cord from the power outlet. When the system is placed into the standby mode, the main power flow is cut and the system is no longer fully operational. You can check the current status of the system with the indicators on the Plasma Display and Media Receiver. indicator Status Plasma Display POWER ON STANDBY Media Receiver POWER ON STANDBY The power cords of both the Plasma Display and the Media Receiver have been disconnected. [. . . ] Turning on and off Teletext 1 Select a TV channel or external input source providing a Each time you press m, the screen switches as shown to the left. If you select a programme with no Teletext signal, "Cannot display Teletext. Use the following remote control buttons to select and operate Teletext pages. You can select a group or block of pages displayed in the coloured brackets at the bottom of the screen by pressing the corresponding colour (RED/GREEN/YELLOW/BLUE) on the remote control unit. [. . . ]