User manual PIONEER PDP-502MXE

[. . . ] Do not force a low-powered amplifier to produce a loud volume of sound (the amplifier's harmonic distortion will be increased, and you may damage the speaker). Please handle the speakers with sufficient care, as the grille net and the cabinet can become damaged or broken when they are subjected to strong external impacts. Placing a CRT computer screen or CRT monitor near to the speakers may result in interference or color distortion. [. . . ] 7 Speaker mounting fittings (used when mounting the speaker so as to allow angle adjustment) When screws other than those enclosed as accessories are used to install the speakers, the speakers may drop off or accidents may be caused. Speakers are designed to allow the two methods of installation shown, in accordance with the user's preference: 1. Flush: Speakers are mounted flat against the sides of the display, and fixed in position (non-adjustable). Air: Speakers are mounted apart from the sides of the display, so as to allow adjustment of their angles. This product is marketed assuming that it is installed by qualified personnel with enough skill and competence. Always have an installation specialist or your dealer install and set up the product. PIONEER cannot assume liabilities for damage caused by mistake in installation or mounting, misuse, modification or a natural disaster. If you install the speakers flush /air, you cannot use the buttons on the right side of the display. See the Operating Instructions packed together with the stand for how to assemble the stand. White with gray line White For the output terminals on the plasma display, push the lever, insert the cable into the hole, and release the lever. 2 After pulling up the locking lever, change the speaker angle as desired, then push the locking lever down again. After connection to the terminals, pull lightly on the cable to confirm that the tips of the cable are properly connected to the terminals. When cable cores stick out and ª and · Lines are shortcircuited, an excessive load will be applied to the plasma display and the operation will stop or trouble will be caused. When the polarity is reversed for one speaker (left or right) at the time of connection to the plasma display, the bass reproduction will be reduced, the sound positioning will be lost, and a correct stereo effect will not be obtained. If you insert the speaker cord too far so that the insulation is touching the speaker terminal, you may not get any sound. Speed clamps are included with the plasma display for tidying your cables and keeping extra cable length out of the way. Organize cables together using the speed clamps provided with the plasma display. Insert 1 into an appropriate hole on the rear of the unit, then snap 2 into the back of 1 to fix the clamp. [. . . ] Insert 1 into an appropriate hole on the rear of the unit, then snap 2 into the back of 1 to fix the clamp. When the cabinet is very dirty, wipe with a soft cloth moistened with water-diluted cleanser; then wipe again with a dry cloth. Never use thinner, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces. [. . . ]