User manual PIONEER ND-BC6

[. . . ] € This product features a wide-angle lens, so the near view is wide and the far view is narrow, which may create a false sense of distance. € Do not wash your car with an automatic car wash or high-pressure water as it may result in water entering the camera or the camera falling off. € If the rear view camera comes loose while you are driving it may cause an accident. 5 Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate the equipment. [. . . ] € During the 24-hour period after installing: – Do not apply water to the unit. Adjust the angle so that the bumper or rear edge of the car is displayed at the bottom of the TV screen. 9) Affix the Hook and loop fastener (hard type) to the bottom of the power supply unit, and affix the Hook and loop fastener (soft type) to the mounting location. 1) ① Glass surface ② Make sure it doesn’t touch the wiper ③ Install on the center part Exemple d’installation (Fig. € Use only the parts included with the unit to ensure proper installation. € Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. € Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop. € When mounting this unit, make sure none of the leads are trapped between this unit and the surrounding metalwork or fittings. € To prevent electric shock, do not install the power supply unit in places where it might come in contact with liquids. € Do not mount this unit near the heater outlet, where it would be affected by heat, or near the doors, where rainwater might splash onto it. (Never install in locations such as the above because of the danger of malfunction due to high temperatures. ) • Before drilling any mounting holes always check behind where you want to drill the holes. Do not drill into the gas line, brake line, electrical wiring or other important parts. € If this unit is installed in the passenger compartment, anchor it securely so it does not break free while the car is moving, and cause injury or an accident. € If this unit is installed under a front seat, make sure it does not obstruct seat movement. Route all leads and cords carefully around the sliding mechanism so they do not get caught or pinched in the mechanism and cause a short circuit. € You can use Hook and loop fastener (hard type) to attach directly to a carpet, but do not use the soft type. € Install the power supply unit close enough for the rear view camera cable to reach. 2) Use a cloth or other item to wipe oil, wax, dust and any other dirt from the installation surface. 5) Press the camera stand with your fingers to stick it to the installation surface. Touching the adhesive surface or sticking the unit on a second time reduces adhesive power which may result in the unit coming off. ‘ ② ③ ④ ⑤ Camera stand Top Mark Bottom Make sure to install the rear view camera so that the mark is located on top of the camera. [. . . ] 11) ① ② ③ ④ ⑤ ⑥ ⑦ ⑧ ⑨ Clamps Rear view camera RCA power supply cable Product with a video input jack (Hideaway unit etc. Scuff plate Clamp Waterproof pad Attach the waterproof pad using doublesided tape. ‘ Rear view camera ⑤ Hatch ③ Rubber packing ④ Make a U-shaped loop in the lead outside the rubber packing to prevent rainwater from flowing along the lead into the interior of the vehicle. Note: Specifications and the design are subject to possible modification without prior notice due to improvements. [. . . ]