User manual PIONEER MVH-X370BT

[. . . ] 11 12 13 13 13 Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC Manufacturer: PIONEER CORPORATION 1-1, Shin-ogura, Saiwai-ku, Kawasaki-shi, Kanagawa 212-0031, JAPAN EU Representative’s: Pioneer Europe NV Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium/Belgique http://www. 18 About this manual: • In the following instructions, a USB memory or USB audio player are referred to as “USB device”. € In this manual, iPod and iPhone are referred to as “iPod”. 2 En English: Hereby, Pioneer, declares that this MVH-X370BT is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. [. . . ] ) Allow the unit to retune to a different frequency providing the same station. NEWS [ON], [OFF] 3 En 11 Menu Item SEEK [MAN], [PCH] Description Assign / buttons to seek the stations one by one (manual tuning) or select a station from the preset channels. RTRV USB iPod [1] (effective for low compression rates), [2] (effective for high compression rates), [OFF] Enhance compressed audio and restore rich sound. Not available when; • USB is selected as a source and the MIXTRAX function is set to on. (Not available when [CONTROL iPod/CTRL iPod] is selected in the control mode. [NATURAL], [VOCAL], [CUSTOM1], [CUSTOM1] can be set separately for each source. [CUSTOM2], [FLAT] However, each of the below combinations are set to the same setting automatically. Equalizer level: [+6] to [–6] You can also switch the equalizer by pressing repeatedly (Only for MVH-170UBG/ 170UB). W CTRL*2*3 Cut-off frequency: [50HZ], [63HZ], [80HZ], [100HZ], [125HZ], [160HZ], [200HZ] Output level: [–24] to [+6] Slope level: [–12], [–24] BASS BOOST [0] to [+6] HPF SETTING Only frequencies lower than those in the selected range are output from the subwoofer. Description SLA Cut-off frequency: [OFF], [50HZ], Only frequencies higher than the high-pass filter [63HZ], [80HZ], [100HZ], [125HZ], (HPF) cutoff are output from the speakers. [160HZ], [200HZ] Slope level: [–12], [–24] [+4] to [–4] Adjust the volume level for each source except FM. Each of the below combinations are set to the same setting automatically. *2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 5). 12 En SYSTEM settings You can also access to these menus when the unit is turned off. Search for a different station with the same programming, even if using a preset station. Select the language to display the text information from a compressed audio file. SET*2 [WIRED], [BLUETOOTH] Description Select the appropriate connection method according to your device. English *1 [PW SAVE] is canceled if the vehicle battery is disconnected and will need to be turned back on once the battery is reconnected. When [PW SAVE] is off, depending on connection methods, the unit may continue to draw power from the battery if your vehicle’s ignition does not have an ACC (accessory) position. Description MUTE MODE (Only available for MVH-170UI) [MUTE], [20dB ATT], [10dB ATT] Mute or attenuate sound automatically when a signal from equipment with a mute function is received. Turning on the source is the only operation allowed when this function is on. Clear the Bluetooth device data (device list, PIN code, call history, phone book, preset phone numbers) stored in the unit. [. . . ] FLAC files (Only for MVH-170UI/ 170UBG/170UB) • FLAC file formats cannot be connected via MTP. Flac – iPod touch (1st through 5th generation) – iPod classic – iPod with video – iPod nano (1st through 7th generation) – iPhone 5s – iPhone 5c – iPhone 5 – iPhone 4S – iPhone 4 – iPhone 3GS – iPhone 3G – iPhone • Operations may vary depending on the generation and/or software version of the iPod. Wma En 19 • Users of iPod with the Lightning Connector should use the Lightning to USB Cable (supplied with iPod). € Refer to the iPod manuals for information about the file/format compatibility. [. . . ]