User manual PIONEER M-91 service manual

[. . . ] Never use thinners, benzene, insecticide sprays or other chemicals on or near this unit, since these will corrode the surfaces. Electronic parts have been carefully selected and internal circuitry redesigned to provide the shortest-possible signal paths, thus realizing true club sound with power to spare. 1 Cross-fader "feeling" adjustment: the specific physical sensation of cross fader operation is all-important to the DJ; the "feeling" adjustment provided in this mixer is an industry first, allowing the user to adjust the physical sensation of the slider to personal preferences, for the smoothest possible cross fader operation. 2 Independent cross fader lag cut: the mechanical play (the lag distance before sound begins) at each end of the cross fader slider can be adjusted using the fader lag cut function, thus allowing adjustment of the sound cut when performing scratch play. [. . . ] When set to On, the indicator lights, and CH-1 signals are output at the SEND jacks. When set to [OFF], the indicator goes out and the equalizer circuit is bypassed. Use to select input signal from CH-2 PHONO/LINE input jacks or CH-2 CD input jacks, and send them to the TRIM control. Use to adjust the CH-2 input signal level (range of adjustment: +9 dB to ­). User to adjust the master output volume level (range of adjustment: 0 dB to ­). Use to adjust the volume level of signals at the BOOTH/ SESSION OUT jacks (range of adjustment: +9 dB to ­). This level can be set independently of the setting of the MASTER LEVEL dial. Use to adjust the volume level of the headphones output (range of adjustment: 0 dB to ­). This lever does not function when the monitor SELECT switch (15) is set to [MASTER]. When the monitor SELECT switch (15) is set to [CUE], moving the lever to the left side produces CH-1 monitor output, while moving it to the right produces CH-2 monitor output. When set to On, the indicator lights, and CH-2 signals are output at the SEND jacks. When turned Off, the level meters display the peak levels for CH-1 (left) and CH-2 (right) (see also item 27). The CH-2 fader lever is used to control the level of signals sent to the cross fader. signal level is maximum at scale mark "10 , " and minimum at scale mark "0". When the front panel CH-2 FADER REVERSE switch is set to [ON], the signal level is maximum at scale mark "0, " and minimum at scale mark "10". * The channel fader curve can be adjusted by means of the front panel FADER CURVE dials. Lights when the CH-2 fader start/back cue function is enabled (see also top panel item 31 and front panel item 39). Lights when CH-2 cross-fader start/back cue function is enabled (see also top panel item 31 and front panel item 39). ON/OFF When set to [ON], the top panel's cross fader REVERSE indicator lights, and the cross fader lever operates in the reverse direction (left side becomes CH-2, and right side becomes CH-1). 1 / CH-1 This switch determines whether the fader start operation for the CD player connected to CH-1 is activated by the cross fader lever, or by the CH-1 fader lever. 2 / CH-2 This switch determines whether the fader start operation for the CD player connected to CH-2 is activated by the cross fader lever, or by the CH-2 fader lever. FADER CUT LAG Use to adjust mechanical play at both extremes of the cross fader movement (the range in which lever movement produces no effect). [. . . ] 3 Move the cross fader lever to the side opposite from the channel you wish to start. 4 Adjust the CD player to its cue point and set for cue point standby. 5 Begin moving the cross fader lever with the timing you wish, thereby beginning playback on the CD player. If the cue point has already been set, there is no need to set the CD player again for standby at the cue point. [. . . ]