User manual PIONEER M-90 BK service manual

[. . . ] Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. 1) Designed for high sound quality Electronic parts have been carefully selected and internal circuitry redesigned to provide the shortest-possible signal paths, thus realizing true club sound with power to spare. [. . . ] When one of these buttons is pressed, the indicator lights and the corresponding preset effect is enabled. Each BANK button can be recorded with three effects for CH-1 (at time of shipping, the buttons have been factory preset with typically used effects). BANK 1 is selected in the default condition after power is initially turned on. Holding the button depressed for about one second will cause the touch panel to display the CH-1 effect select menu. To turn effects [ON], either pull switch forward (switch returns automatically to [OFF] when released) or slide to far side to the [LOCK ON] position. When effects are [ON], the indicator flashes and effects are applied to CH-1. In such cases, or if you wish to deliberately set a different BPM, use the TAP button. The BPM value can be changed by rotating the TIME/ SELECT dial while holding the TAP button depressed. Tapping the button in time with the beat will cause the function to switch to the manual BPM count mode; the tapped beat will be counted and displayed as the BPM value. When one of these buttons is pressed, the indicator lights and the corresponding preset effect is enabled. PHONO / LINE Connect to audio output from CH-2 analog turntable, cassette deck or other line signal level component. The display provides a visual standard in addition to the human ear, thus allowing the DJ to quickly match two tracks possessing differing speeds. When auto mode is used to count BPM, the calculated BPM value is displayed on the LCD panel, allowing quick matching of tracks with differing speeds. * Some tracks may not be counted properly, in which case manual count should be used. BPM value display TAP lights during manual count mode (TAP button input) ¶ The BPM value can be input directly by rotating the TIME/SELECT dial while holding the TAP button depressed. ) The supplied hexagonal Allen driver can be used to adjust the hexagonal Allen screw located next to the top panel's cross fader slider opening, thus modifying the sliding resistance of the lever. The mechanical play (the lag or range of movement in which no functional effect takes place) at the two extreme ends of the top panel cross fader lever movement can be adjusted by using the front panel's FADER CUT LAG dial, within a range of 1 - 6 mm. The front panel's FADER CURVE dials can be used to adjust the attenuation curve response of the cross fader and channel fader. The cross fader can be adjusted independently for CH-1 and CH-2 sides. By pressing the top panel's FADER CURVE/BANK EDIT button, the adjustment status can be displayed on the touch panel. Cross fader cut lag dimension display Affichage de dimension du retard de coupure au fondu croisé The operating directions of the CH-1, CH-2 and cross fader levers can be reversed by setting the front panel's FADER REVERSE switches to their [ON] positions. When the CH-1 (or CH-2) FADER REVERSE switch is set to [ON], the top panel CH-1 (or CH-2) REVERSE indicator lights, and the corresponding lever's operating direction is reversed (scale mark "0" becomes attenuation 0 dB, while scale mark "10" becomes minus infinity). [. . . ] The fader used for fader effects can be set to either channel fader or cross fader. When the EFFECT switch is set to [ON] by pulling the switch forward, the switch will automatically return to [OFF] when released. note: · Make selection of effects and type of fader (channel or cross) only when the EFFECT switch is in the [OFF] position. If effects are selected when the EFFECT switch is in the [LOCK ON] position, noise may be produced. [. . . ]