User manual PIONEER KEH-P9200RDS

[. . . ] Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out. Fixing screw If you do not operate the Removing and Attaching the Front Panel Function, use the supplied fixing screws and fix the front panel to this unit. [. . . ] Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. Support Après avoir introduit le support dans le tableau de bord, sélectíonnez les languettes appropriées en fonction de l'épaisseur du matériau du tableau de bord et courbez-les. This unit is for vehicles with a 12-volt battery and negative grounding. before installing it in a recreational vehicle , truck , or bus , check the battery voltage. To avoid shorts in the electrical system, be sure to disconnect the battery cable before beginning installation. Refer to the owner's manual for details on connecting the power amp and other units, then make connections correctly. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. ISO connector Note: In some vehicles, the ISO connector may be divided into two. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. Speaker leads White : Front left + White/black : Front left Gray : Front right + Gray/black : Front right Green : Rear left + Green/black : Rear left Violet : Rear right + Violet/black : Rear right 17. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. Please ground this lead separately from the ground of high-current products such as power amps. If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire. ISO connector Note: In some vehicles, the ISO connector may be divided into two. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. [. . . ] ISO connector Note: In some vehicles, the ISO connector may be divided into two. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. Speaker leads White: Front left + White/black: Front left Gray: Front right + Gray/black: Front right Green: Rear left + Green/black: Rear left Violet: Rear right + Violet/black: Rear right Cords for this product and those for other products may be different colors even if they have the same function. [. . . ]