User manual PIONEER KEH-P7100RDS

[. . . ] To protect the wiring, wrap adhesive tape around them where they lie against metal parts. Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake, and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. [. . . ] Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. Don't pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short. Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. When replacing fuse, be sure to use only fuse of the rating prescribed on this unit. Since a unique BPTL circuit is employed, never wire so the speaker leads are directly grounded or the left and right speaker leads are common. Please ground this lead separately from the ground of high-current products such as power amps. ISO connector Note: In some vehicles, the ISO connector may be divided into two. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. Front speaker + Rear speaker Left + Subwoofer Speaker leads White : Front left + White/black : Front left Gray : Front right + Gray/black : Front right Green : Rear left + or Subwoofer + Green/black : Rear left or Subwoofer Violet : Rear right + or Subwoofer + Violet/black : Rear right or Subwoofer + Use this for connections when you have the separately available amplifier. Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly. Use only the parts included with the unit to ensure proper installation. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. [. . . ] Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. [. . . ]