User manual PIONEER KEH-P6000RDS

[. . . ] If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. ⷠDon't pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short. [. . . ] ⷠNever feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. When replacing fuse, be sure to use only fuse of the rating prescribed on the fuse holder. ⷠSince a unique BPTL circuit is employed, never wire so the speaker leads are directly grounded or the left and right speaker leads are common. Please ground this lead separately from the ground of high-current products such as power amps. If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire. ⷠSpeakers connected to this unit must be highpower types with minimum rating of 45 W and impedance of 4 to 8 ohms. Connecting speakers with output and/or impedance values other than those noted here may result in the speakers catching fire, emitting smoke, or becoming damaged. Rear speaker Perform these connections when using a different amp (sold separately). Power amp (sold separately) Connecting cords with RCA pin plugs (sold separately) Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly. ⷠUse only the parts included with the unit to ensure proper installation. ⷠConsult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. ⷠInstall the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. ⷠIf installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. This unit can be properly installed either from "Front" (conventional DIN Front-mount) or "Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). [. . . ] This unit can be properly installed either from "Front" (conventional DIN Front-mount) or "Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. The release pin into the hole in the bottom of the frame and pull out to remove the frame. [. . . ]