User manual PIONEER HTZ-333DVD 1

[. . . ] · If reception with the supplied antenna is poor, see the Other connections section in the main operating instructions for details on connecting outdoor antennas. 1 Pull off the protective shields of both AM antenna wires. Precautions: · The remote control may not work if there is an obstacle between the remote control and the display unit, or if the remote control is not directed towards the remote sensor of the display unit at the correct angle. · The remote control may not work properly if strong light such as direct sunlight or fluorescent light is shining onto the unit's remote sensor. · The remote control may not work properly when this unit is used near devices emitting infrared rays, or when remote controls of other devices which use infrared rays are used. [. . . ] · In order to prevent battery leakage, remove the batteries when not using the remote control for an extended period (one month or more). If leakage occurs, carefully wipe away any battery fluid inside the compartment, and replace the batteries with new ones. · Do not allow books or other objects to rest on top of the remote control, since the buttons may be depressed, causing faster exhaustion of the batteries. Precautions: · When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Otherwise, the speaker may fall from the TV due to external shocks such as earthquakes, endangering those nearby or damaging the speaker. · Do not connect the supplied speakers with any other amplifier. · The front, center and surround speakers supplied with this system are magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker is installed extremely close to the screen of a television set. If this happens case, turn the power switch of the television set OFF, and turn it ON after 15 to 30 minutes. If the problem persists, place the speaker system away from the television set. · The subwoofer is not magnetically shielded and so should not be placed near a TV or monitor. Since it is not magnetically shielded, do not place any magnetic storage media (such as floppy disks and tape or video cassettes) close to the subwoofer. · Do not fix the subwoofer and center speaker to the wall or ceiling; they could cause injury if they fell. AM loop antenna Microphone (for Auto MCACC setup) Note: If you plan to mount the AM antenna to a wall or other surface, secure the stand with screws (fig. Make sure the reception is clear. 1 2 3 5 Place the AM antenna on a flat surface and point in the direction giving the best reception. Don't let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances. 6 Connect the FM wire antenna to the FM UNBAL 75 antenna terminal. For best results, extend the FM antenna fully and fix to a wall or door frame. Don't drape loosely or leave coiled up. Note: The signal earth (H) is designed to reduce noise that occurs when an antenna is connected. It is not an electrical safety earth. 3 Connect each speaker using the color-coded speaker cords. Match them to the colored speaker terminals on the rear panel of the DVD/CD receiver. Surround right (Grey) Surround left (Blue) Connect each speaker as shown below. Color-coded wire (Connect to speaker) Color-coded connector (Connect to rear panel) 4 Connect the DVD/CD receiver to your TV, then connect the supplied power cord. 1 2 Connect one end to a video input on your TV. Use the supplied video cord. 1 Twist and pull off the protective shields on each wire. Connect the other end to the video output of the DVD/CD receiver. This player is equipped with copy protection technology. Do not connect this player to your TV via a VCR using AV cables, as the picture from this player will not appear properly on your TV. * Illustration shows the Taiwan model 2 Connect the wires to the IN 6 FRONT IN OUT 6 CENTER MCACC MIC L R TV AUDIO LINE 1 SPEAKERS 6 Listening position Subwoofer (Purple) L R 6 6 SUB WOOFER L 6 R SURROUND speaker. Match the colored wire with the color-coded label (above the tabs), then insert the colored wire into the red (+) tab and the other wire with the black (­) tab. 3 Connect the power cord to the AC inlet. VIDEO IN 3 Connect the other end to the colorCenter (Green) Front right (Red) Front left (White) Upper three terminals For the best surround sound, setup your speakers as above. [. . . ] The base of each surround speaker fits into the circular groove on the top of the front speakers as shown. 4 Turn the surround speakers towards the closest wall, lining the arrows up for optimal Front Surround. Turn each surround speaker so that the arrow at the base is lined up with the FRONT SURROUND arrow on the front speaker. With ExtPower (Extra Power), line up the arrow with the EXTRA POWER arrow Front speakers (the surround speakers should be in the same direction as the front speakers). See the operating instructions for more on the Front Surround modes. Center Subwoofer 3 Secure the speaker wire. After testing for the slack necessary to turn the speaker (see the following step), use the groove provided to secure the speaker wire as shown. [. . . ]