User manual PIONEER HTP-SL050

[. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] ¶ The rear (surround) speakers are most effective when installed in parallel locations directly to the side, or slightly behind, the listener, at a level about 1 meter above the listener's ears. ¶ Do not install this speaker system near a stove or other heating appliance, or put it in a place exposed to the sun. Such locations may cause the cabinet to change color and the speaker system to break down. ¶ Remeber that this speaker system is quite heavy, so it is dangerous to install it in a high place such as on a wall or pillar or in other unstable locations. The subwoofer plays back the bass in monaural, making use of the fact that the human ear loses the sense of direction of low-pitched sound. Since the sense of direction is lost, the subwoofer can be installed almost anywhere. If it is installed too far away, however, the sound from the left and right speakers may become unnatural. The VCR deck may produce noise when played back depending on the place of installation. Center speaker Front left speaker Front right speaker Subwoofer Listening area Rear left speaker Rear right speaker Leaving cables in a loop on the unit as shown in the figure above may cause humming noise due to leakage of the transformer to be heard from the speakers. The size of characters in the figure may different from that on the actual product. LEVEL button Use to adjust center or rear level CENTER/REAR button Use to select the Level Control. When 3 STEREO is selected in the center mode, no test tone from the surround speaker is output. Center or rear sound is coming out, adjust the center level and rear level so that the test tone volume output from each speaker is the same. The BALANCE L, R buttons of this unit can be used to adjust the FRONT balance. ¶ The TEST TONE signal will not be output in the SFC mode, but the only rear level can be adjusted. As the SURROUND speaker is normally placed near the listening position, it is nearer to the listening position than the FRONT speaker. Subsequently, since the sounds from the SURROUND speaker will be heard quicker than those from the FRONT speaker, set the delay time for the sounds from the SURROUND speaker so that the SURROUND and FRONT speakers are virtually the same distance from the listening position. ¶ Initially the distance from the listening position to the SURROUND speaker will be set shorter than that from to the FRONT speaker. ¶ When 3 STEREO is selected in the center mode, the delay time cannot be set. Selecting broadcast stations (For example, when selecting an FM broadcast) Over 2 second, then release) Stop when received or pressed again 7 Selecting a broadcast station using the main unit 2 The TUNED indicator will not light when a broadcast station is too far away or when the broadcasting signal is weak. The selection will be memorized in the specified station number 5 seconds later. Pressing the MEMORY button within 5 seconds will exit the MEMORY mode. [. . . ] Press any one of buttons in the MULTI CONTROL function area, which is input preset codes (P. 1 (Power) STANDBY/ON Use to turn STANDBY/ON the CD player or MD player. 44 Pressing and releasing this button immediately returns playback to the beginning of the track currently being played. pressing it continuously returns playback to the beginning of a previous track. [. . . ]