User manual PIONEER HDJ-1500-K

[. . . ] If they are not, an accidental detachment may result in a fire or malfunction. 8 9 a b c d Hard-wired remote control adaptor can be connected (sold separately). Microphone input Microphone 4m Rear output or high range output Front output or middle range output Subwoofer output or low range output USB cable 1. If connecting both USB1 (USB storage device1)/iPod1 (iPod connected using USB input1) and USB2 (USB storage device2)/iPod2 (iPod connected using USB input2) at the same time, use a Pioneer USB cable (CD-U50E) in addition to the regular Pioneer USB cable. [. . . ] Power cord 3 4 This unit 9 3 2 1 d c 4 56 78 a b 2 5 6 1 3 7 8 9 5 4 6 c a b 1 USB port 1 2 USB port 2 3 Antenna input 15 cm 4 Audio input 5 Fuse (10 A) 6 Power cord input 7 Wired remote input e d 1 To power cord input 2 Depending on the kind of vehicle, the function of 3 and 5 may be different. 9 Black (chassis ground) a Blue/white The pin position of the ISO connector will differ depending on the type of vehicle. D Speaker leads White: Front left + or middle range left + White/black: Front left * or middle range left * Gray: Front right + or middle range right + Gray/black: Front right * middle range right * Green: Rear left + or high range left + Green/black: Rear left * or high range left * Violet: Rear right + or high range right + Violet/black: Rear right * or high range right * OF STAR 2 En T Section Connections Connections 01 e ISO connector In some vehicles, the ISO connector may be divided into two. For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. If using this system, we recommend that this unit’s internal amp is turned off. For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. The following signals are output from the speaker leads when this connection is in use. White: Middle range left + White/black: Middle range left * Gray: Middle range right + Gray/black: Middle range right * Green: High range left + Green/black: High range left * Violet: High range right + Violet/black: High range right * 1 5   !If using this system, we recommend that this unit’s internal amp is turned off. For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. Switching between RCA input modes % Use a thin, flathead screwdriver to change the RCA input mode switch on the bottom of this unit. When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents. 1 Dashboard 2 Mounting sleeve 3 Install the unit as illustrated. 1 3 2 Leave ample 5 cm space 5 cm 5cm cm 4 5 1 2 3 4 5 If connecting the unit to a car stereo with RCA output 1 2 3 4 !H (High) - If inputting from the speaker output of a connected device DIN front/rear mount This unit can be properly installed using either front-mount or rear-mount installation. Nut Firewall or metal support Metal strap Screw Screw (M4 × 8) 1 Car stereo with RCA output 4 En Section Installation Installing the microphone 02 03 # Make sure that the unit is installed securely in place. 2 Insert the supplied extraction keys into both sides of the unit until they click into place. CAUTION It is extremely dangerous to allow the microphone lead to become wound around the steering column or shift lever. Be sure to install the unit in such a way that it will not obstruct driving. Note Install the microphone in a position and orientation that will enable it to pick up the voice of the person operating the system. [. . . ] Note Install the microphone in a position and orientation that will enable it to pick up the voice of the person operating the system. 1 English DIN Rear-mount 1 Determine the appropriate position where the holes on the bracket and the side of the unit match. Removing and re-attaching the front panel You can remove the front panel to protect your unit from theft. Press the detach button and push the front panel upward and pull it toward you. [. . . ]