User manual PIONEER GR-470

[. . . ] The white plug is for the left channel, and the red plug is for the right channel. If your stereo amplifier has only one set of TAPE/ADAPTOR or TAPE MONITOR jacks, connect them to the graphic equalizer's INPUT and OUTPUT terminals. When stereo amplifier has two sets of tape/adaptor jacks: Connect [INPUT] jacks to the stereo amplifier's TAPE2/ ADAPTOR [REC] or TAPE2 MONITOR [REC] jacks, and connect [OUTPUT] jacks to the stereo amplifier's TAPE2/ ADAPTOR [PLAY] or TAPE2 MONITOR [PLAY] jacks. [. . . ] Be sure to switch power to standby and remove the power cord from the wall outlet when you make or change connections. Be sure to switch power to standby and remove the power cord from the wall outlet when you make or change connections. Accessory cord provided with GR-470/ Cordon accessoire fourni avec le GR-470 Stereo amplifier/ Amplificateur stéréophonique Power plug/ Fiche du cord o n d'alimentation or AC wall outlet/ ou vers une prise secteur murale When this switch is set to the ON position, power is supplied to the unit's main circuits (Equalizer indicators lights). Even when performing playback without using the functions of this component, be sure that its STANDBY/ON switch is ON. If the STANDBY/ON switch is STANDBY, no sound will be produced from the speakers. When this button is pressed, the equalizer ON indicator lights and its functions become operative. When pressed once again, this indicator goes out and the unit's functions are turned OFF, Use this button in the following manner: ON : When using the equalizer to add sound compensation. OFF : When not using the equalizer, but playing back or recording program sources without compensation. When the 6 kHz frequency is boosted, the cymbals and "high hat" sound much clearer. Instruments and vocals have a great many harmonic components along with the fundamental frequency band and so you can have lots of fun operating 7 controls to achieve the sound of your choice. In order to protect the speakers from damage resulting from power overload, do not excessively increase the stereo amplifier's volume level when boosting the treble range on this unit. The sound of vocals and instruments can be colored at will by operating the controls. 4 kHz controls are raised and the other controls lowered, people's voices sound as if heard on a telephone. Preventing howl during mixing play Any irritating howl during play can be prevented by lowering the knob corresponding to the frequency band in which the howl occurs. Noise can be reduced during recording and playback When the high-range controls are boosted in step fashion during recording and then lowered in reverse fashion during playback, tape hiss and other high-range noise can be reduced. A sound with a greater "punch" can be recorded for playback on car stereo equipment if the ultra-low-range, which is hard to hear, is cut out and the mid-range is boosted. [. . . ] A sound with a greater "punch" can be recorded for playback on car stereo equipment if the ultra-low-range, which is hard to hear, is cut out and the mid-range is boosted. When tape deck 1 connected to the stereo amplifier is set to the recording mode, the contents of the equalizer-compensated broadcast can be recording on cassette tape. If you think that there is something wrong with this component, check the points below. [. . . ]