User manual PIONEER FH-460UI

[. . . ] ователя Italiano Español Deutsch Nederlands Русский <QRD3247-A>1 Black plate (2, 1) Section 01 Before you start Before you start Thank you for purchasing this PIONEER product To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. About this unit The tuner frequencies on this unit are allocated for use in Western Europe, Asia, the Middle East, Africa and Oceania. [. . . ] 12H (12-hour clock)—24H (24-hour clock) AUTO PI (auto PI seek) The unit can automatically search for a different station with the same programming, even during preset recall. AUX (auxiliary input) Activate this setting when using an auxiliary device connected to this unit. You can also change the dimmer setting by pressing and holding /DIMMER. MUTE MODE (mute mode) System menu Important PW SAVE (power saving) is canceled if the vehicle battery is disconnected and will need to be turned back on once the battery is reconnected. When PW SAVE (power saving) is off, depending on connection methods, the unit may continue to draw power from the battery if your vehicle’s ignition doesn’t have an ACC (accessory) position. 8 En <QRD3247-A>8 Black plate (9, 1) Section Using this unit Using this unit 02 Sound from this system is automatically muted or attenuated when a signal from equipment with a mute function is received. 10dB ATT – Attenuation PW SAVE (power saving) Switching this function on enables you to reduce the consumption of battery power. Turning on the source is the only operation allowed when this function is on. SP-P/O MODE (rear output and preout setting) The rear speaker leads output and the RCA output of this unit can be used to connect a full-range speaker or subwoofer. W – Select when there is a fullrange speaker connected to the rear speaker leads output and there is a subwoofer connected to the RCA output. W – Select when there is a subwoofer connected directly to the rear speaker leads output without any auxiliary amp and there is a subwoofer connected to the RCA output. REAR/REAR – Select when there is a fullrange speaker connected to the rear speaker leads output and the RCA output. If there is a full-range speaker connected to the rear speaker leads output and the RCA output is not used, you may select either REAR/SUB. Note AUX cannot be selected unless the auxiliary setting is turned on. English Switching the display Selecting the desired text information 1 Press DISP to cycle between the following: !Source name and clock If an unwanted display appears Turn off the unwanted display using the procedures listed below. Using an AUX source 1 Insert the stereo mini plug into the AUX input jack. en 9 <QRD3247-A>9 Black plate (10 , 1) Section 03 Installation Installation Connections Important !When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. Use of this unit in conditions other than the following could result in fire or malfunction. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. € Disconnect the negative terminal of the battery before installation. [. . . ] Pioneer cannot guarantee compatibility with all USB mass storage devices and assumes no responsibility for any loss of data on media players, smart phones, or other devices while using this product. Do not leave discs or a USB storage device in any place that is subject to high temperatures. Audiobook, Podcast: Compatible iPod compatibility This unit supports only the following iPod models. IPhone Depending on the generation or version of the iPod, some functions may not be available. [. . . ]