User manual PIONEER F-J210

[. . . ] If the battery is disconnected or discharged, any preset memory will be erased. Function setting operations are completed even if the menu is cancelled before the operations are confirmed. Failure to connect the red lead (ACC) of this unit to a terminal coupled with ignition switch on/off operations may lead to battery drain. Remember that if the feature demo continues operating when the car engine is turned off, it may drain battery power. [. . . ] After selecting, perform the following procedures to set the function. To complete the connection, check the device name (F-J210) and enter the link code on your cellular phone. If five devices are already paired, DEVICEFULL is displayed and it is not possible to perform this operation. (setting a special device) Bluetooth devices that are difficult to establish a connection with are called special devices. If your Bluetooth device is listed as a special device, select the appropriate one. If five devices are already paired, DEVICEFULL is displayed and it is not possible to perform this operation. To complete the connection, check the device name (F-J210) and enter the link code on your cellular phone. VISIBLE (setting the visibility of this unit) To check the availability of this unit from other devices, Bluetooth visibility of this unit can be turned on. PIN CODE (PIN code input) To connect your cellular phone to this unit via Bluetooth wireless technology, you need to enter a PIN code on your phone to verify the connection. Returns you to the PIN code input display, and you can change the PIN code. Important Be sure to park your vehicle in a safe place and apply the parking brake when performing this operation. If the screw for the ground wire loosens or falls out, it could result in fire, generation of smoke or malfunction. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. -- Place all cables away from moving parts, such as the gear shift and seat rails. -- Place all cables away from hot places, such as near the heater outlet. -- Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. -- Never cut the insulation of the power cable of this unit in order to share the power with other devices. Perform these connections when using a subwoofer without the optional amplifier. Power cord input Microphone input Microphone Rear output or subwoofer output Front output Antenna input Fuse (10 A) Wired remote input Hard-wired remote control adaptor can be connected (sold separately). Perform these connections when not connecting a rear speaker lead to a subwoofer. Metal parts of car's body When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. [. . . ] To clean a CD, wipe the disc with a soft cloth outward from the center. To ensure proper operation, connect the dock connector cable from the iPod directly to this unit. Do not let the iPod fall onto the floor, where it may become jammed under the brake or accelerator pedal. Playable folder hierarchy: up to eight tiers (A practical hierarchy is less than two tiers. [. . . ]