User manual PIONEER F-401 schematics

[. . . ] Do not connect either wire to the earth terminal of a three pin plug. NOTE After replacing or changing a fuse, the fuse cover in the plug must be replaced with a fuse cover which corresponds to the colour of the insert in the base of the plug or the word that is embossed on the base of the plug, and the appliance must not be used without a fuse cover. To prevent a fire hazard, do not place any naked flame sources (such as a lighted candle) on the D3-4-2-1-7a_A_En equipment. When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 5 cm at rear, and 5 cm at each side). [. . . ] Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement. This product complies with the Low Voltage Directive (73/23/EEC, amended by 93/68/EEC), EMC Directives (89/336/EEC, amended by 92/31/EEC and 93/68/EEC). d3-4-2-1-9a_En If the AC plug of this unit does not match the AC outlet you want to use, the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. if connected to an AC outlet , the cut-off plug can cause severe electrical shock. The equipment should be disconnected by removing the mains plug from the wall socket when left unused for a long period of time (for example, when D3-4-2-2-1a_A_En on vacation). You can find the voltage selector switch on the bottom plate of the unit. the factory setting for the voltage selector is 220 ­ 240 V. Player control connector, used to control player, fader start and other operations (minijack x 1). Use the control cable (provided with DVJ-X1) to connect to player B's CONTROL connector. The sync signal is used to synchronize video signals between players A and B, thus preventing video distortion resulting from mix-matched signals when switching between images. Use the BNC plug coaxial cable (furnished with this unit) to connect to player B's SYNC IN connector. Note: In order to produce the various video system outputs, the same input system signals are necessary (the unit does not perform video signal conversion). Composite video output connector for player A or player B as selected by this unit (RCA pin jack). Use the control cable (furnished with this unit) to connect to the CONTROL connector of the channel which will control the DJ mixer's player B. S-Video output connector for player A or player B as selected by this unit (4-pin mini DIN connector). In order to support very quick switching of video signals, this unit does not support S2 video signals. Component video output connectors for player A or player B as selected by this unit (BNC connectors x 3). Use a video cable (supplied with DVJ-X1) to connect to player A's VIDEO OUT connector. [. . . ] This component is designed to allow use of a fader start signal output from a DJ mixer to perform automatic signal switching; it also generates sync signals to help suppress image distortion when switching between video signals. Power is turned ON when this button is depressed to the lock position. When power is first turned ON, PLAYER A input is selected, and the VIDEO A button's outer-ring indicator lights. The AUTO button also lights, indicating that the AUTO mode is selected, and the fader start signal from the DJ mixer is used to perform automatic input selection. [. . . ]