User manual PIONEER DJM-350-W

[. . . ] The Pioneer website listed above provides answers to frequently asked questions, information about software, and other up-to-date data of assistance to our customers. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. [. . . ] DJ performances can be recorded onto and played from USB devices (page 12). Effects can be applied to the sound output from [MASTER OUT 1, 2] (page 11). About the power switch of this unit To turn the power on press [u] 1. When this unit's power is on, press [u] 1 for at least 2 seconds. Note that very loud sounds will be output if the volume is set too high. To output the sound of channel 2 ([CH-2]) 2, perform the procedure below replacing [CH-1] with [CH-2]. Select the input source for [CH-1] from among the devices connected to this unit. The [CH-1] channel level indicator f lights when audio signals are being properly input to [CH-1]. Adjust [TRIM] so that the orange indicator lights at the point in the track where the volume is loudest (the climax, etc. Be careful that the red indicator does not light, or the sound could be distorted. (When the crossfader moves away from either the left or right edge, the sound is immediately output from the opposite side. This operation is not necessary when the [THRU, fader curve selector) switch is set to [THRU]. Adjust [MASTER LEVEL] so that the orange indicator lights at the point in the track where the volume is loudest (the climax, etc. Be careful that the red indicator does not light, or the sound could be distorted. While checking the sound output from the speakers, operate the crossfader to substitute the sound of [CH-1] with the sound of [CH-2]. Mixing is completed once only the [CH-2] sound is being output from the speakers. Using the fader to play a Pioneer DJ player (fader start) If you connect a Pioneer DJ player using a control cable (supplied with a DJ player), you can start playback of control other operations of the DJ player with the fader of this unit. The fader start function can only be used when connected to a Pioneer DJ player. Refer to Specifications on page 16 for the range of sound that can be adjusted by each control. The sound for that range can be turned completely off by turning the control all the way counterclockwise (isolator function). Prepare the unit in advance so that the sound of [CH-1] 1 is being output from the speakers. For instructions on monitoring the sound, see Monitoring the sound over headphones (headphones section) on page 11. [. . . ] If this unit cannot operate normally, the [u] (the power switch), [USB STOP] and [PLAY f] indicators flash to indicate an error. If the same error is indicated after the measures have been taken, contact your store of purchase or nearby Pioneer service station. Number of times indicator flashes 2 times repeatedly 3 times repeatedly Check the table below and take the measures indicated. File format problem You are using a USB device with a file system that is not supported by this unit. [. . . ]