User manual PIONEER DEH-9350SD

[. . . ] Before You Start About this unit 2 In case of trouble 2 Demo mode 2 Reverse mode 3 About this manual 3 Operating this unit Head unit 3 Remote control 3 Basic Operations 4 Use and care of the remote control 4 Menu operations identical for function settings/audio adjustments/initial settings/lists 4 Tuner 5 CD/CD-R/CD-RW and external storage devices (USB, SD) 5 iPod 7 Audio Adjustments 8 Initial Settings 9 Other Functions 10 Installation Connections Installation Thank you for purchasing this PIONEER product. To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. [. . . ] USB memory ­When a USB storage device is used, a song can be selected from the artist/album/song/genre list. SD card ­When an SD card is used, a song can be selected from the artist/album/ song/genre list. Warning tone (warning tone setting) If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. AUX (auxiliary input) Activate this setting when using an auxiliary device connected to this unit. Dimmer (dimmer setting) To prevent the display from being too bright at night, the display is automatically dimmed when the car's headlights are turned on. When dimmer is functioning, the brightness level can be adjusted 0 to 10. S/W control (rear output and subwoofer setting) This unit's rear output (rear speaker leads output and RCA rear output) can be used for full-range speaker (Rear SP :F. If you switch the rear output setting to Rear SP :S/W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Even if you change this setting, there will be no output unless you turn the subwoofer output on (refer to Sub W. If you change this setting, subwoofer output in the audio menu will return to the factory settings. Both rear speaker lead outputs and RCA rear output are switched simultaneously in this setting. You can also turn on or off feature demo by pressing DISP while this unit is turned off. You can also turn on or off reverse mode by pressing BAND while this unit is turned off. Note AUX cannot be selected unless the auxiliary setting is turned on. # Even if the display indication is turned off, operation can be conducted. If operation is conducted while the display indication is off, display will light up for a few seconds and then turn off again. Use speakers over 50 W (output value) and between 4 W to 8 W (impedance value). When installing this unit or power amp (sold separately), make sure to connect the ground wire first. Ensure that the ground wire is properly connected to metal parts of the car's body. The ground wire of the power amp and the one of this unit or any other device must be connected to the car separately with different screws. If the screw for the ground wire loosens or falls out, it could result in fire, generation of smoke or malfunction. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. [. . . ] This unit may not operate correctly depending on the application used to encode WMA files. There may be a slight delay when starting playback of audio files embedded with image data. Since the CD side of DualDiscs is not physically compatible with the general CD standard, it may not be possible to play the CD side with this unit. Playable folder hierarchy: up to eight tiers (A practical hierarchy is less than two tiers. [. . . ]