User manual PIONEER DEH-9300SD

[. . . ] Operation Manual CD RDS RECEIVER DEH-9300SD English Contents Thank you for purchasing this PIONEER product. To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. Before You Start About this unit 3 In case of trouble 3 Demo mode 3 Reverse mode 4 Sound muting 4 About this manual 4 Operating this unit Head unit 5 Optional remote control 5 Basic Operations 6 Menu operations identical for function settings/audio adjustments/initial settings/ lists 6 Tuner 6 CD/CD-R/CD-RW and external storage devices (USB, SD) 9 iPod 11 Audio Adjustments 13 Initial Settings 15 Other Functions 16 Additional Information Troubleshooting 18 Error messages 18 Handling guidelines 20 Compressed audio compatibility (disc, USB, SD) 21 iPod compatibility 23 Sequence of audio files 23 Copyright and trademark 23 Specifications 25 2 En Section Before You Start 01 Before You Start If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. CAUTION This product is a class 1 laser product classified under the Safety of laser products, IEC 60825-1:2007, and contains a class 1M laser module. [. . . ] Only frequencies lower than those in the selected range are outputted from the subwoofer. HPF (high pass filter adjustment) When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are output from the front or rear speakers. 50Hz--63Hz--80Hz--100Hz--125Hz SLA (source level adjustment) SLA (Source Level Adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. Adjustment range: +4 to ­4 14 En Section Operating this unit Initial Settings This setting allows you to measure the length of time that elapses from when the machine is turned on and display the amount of elapsed time per set period. OFF--15Minutes--30Minutes FM step (FM tuning step) Normally, the FM tuning step employed by seek tuning is 50 kHz. When AF or TA is on, the tuning step automatically changes to 100 kHz. 50kHz (50 kHz)--100kHz (100 kHz) Auto PI (auto PI seek) The unit can automatically search for a different station with the same programming, even during preset recall. USB plug&play (plug and play) Language select (multi-language) For your convenience, this unit equips multiple language display. English--Français--Italiano--Español-- Deutsch--Nederlands-- Calendar (setting the date) 1 Push M. C. left or right to select the segment of the calendar display you wish to set. left or right to select the segment of the clock display you wish to set. (e. g. , 10:36 becomes 11:00. ) EngineTime alert (elapsed time display setting) This setting allows you to switch your source to USB/ IPOD automatically. ON ­ When USB storage device/iPod is connected, the source is automatically switched to USB/IPOD. If you disconnect your USB storage device/iPod, this unit's source is turned off. OFF ­ When USB storage device/iPod is connected, the source does not switch to USB/ IPOD automatically. Warning tone (warning tone setting) If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. AUX (auxiliary input) Activate this setting when using an auxiliary device connected to this unit. Dimmer (dimmer setting) To prevent the display from being too bright at night, the display is automatically dimmed when the car's headlights are turned on. to turn dimmer on or off. 02 Operating this unit 1 1 Function display !After selecting, perform the following procedures to set the initial setting. En 15 Section 02 Operating this unit Brightness (display brightness setting) 1 Push M. C. When dimmer is functioning, the brightness level can be adjusted 0 to 10. [. . . ] 7, 7. 1, 8, 9, 10, 11, 12 (2ch audio) (Windows Media Player) AAC decoding format . . . . . . . . . . . . Linear PCM & MS ADPCM (Non-compressed) Additional Information Audio Maximum power output . . . . . . . 50 W × 4 50 W × 2/4 W + 70 W × 1/2 W (for subwoofer) Continuous power output . . . 22 W × 4 (50 Hz to 15 000 Hz, 5 % THD, 4 W load, both channels driven) Load impedance . . . . . . . . . . . . . . . . . . . . . . [. . . ]