User manual PIONEER DEH-80PRS

[. . . ] Connect this cable to the system remote control of an external power amp or the vehicle’s auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. [. . . ] 2 Power amp (sold separately) 3 Connect with RCA cable (sold separately) 4 To low range output 5 Low range speaker 1 System remote control Connect to Blue/white cable. 2 Power amp (sold separately) 3 Connect with RCA cable (sold separately) 4 To high range output 5 High range speaker 6 To middle range output 7 Middle range speaker 8 To low range output 9 Low range speaker Switching the DSP setting mode This unit features two operation modes: the 3way network mode (NW) and the standard mode (STD). For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. En 3 Section 01 02 Connections Installation WARNING Do not use the unit in standard mode when a speaker system for 3-way network mode is connected to this unit. 1 Use a thin, flathead screwdriver to change the DSP switch on the bottom of this unit. 2 To audio output 3 Connect with RCA cable (sold separately) 4 To audio input If connecting the unit to a car stereo with no RCA output 2 3 4 5 6 7 8 1 Important !Consult your dealer if installation requires drilling of holes or other modifications to the vehicle. Do not install this unit where: — it may interfere with operation of the vehicle. If there is enough space, use the mounting sleeve that came with the vehicle. 2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place. 1 1 2 3 4 5 6 7 2 Press RESET with a pen tip or other pointed instrument. Install this unit away from hot places such as near the heater outlet. Optimum performance is obtained when the unit is installed at an angle of less than 60°. 60° 2 Audio input If you connect the unit to an audio device with RCA output, or to one with no RCA output, you can set it up so that the audio from the audio device is output through speakers connected to the unit. [. . . ] 1 2 1 Microphone clip 2 Clamp 1 3 2 1 Tapping screw (5 mm × 8 mm) 2 Mounting bracket 3 Dashboard or console When installing the microphone on the steering column 1 Install the microphone on the microphone clip. 1 Microphone 2 Microphone clip 2 Install the microphone clip on the sun visor. ) 3 4 1 Microphone 2 Microphone base 3 Microphone clip 4 Fit the microphone lead into the groove. [. . . ]