User manual PIONEER DEH-6350SD

[. . . ] Before You Start About this unit 2 Demo mode 2 In case of trouble 2 About this manual 3 Operating this unit Head unit 3 Remote control 3 Display indication 4 Basic Operations 4 Use and care of the remote control 4 Menu operations identical for function settings/audio adjustments/initial settings/lists 5 Tuner 5 CD/CD-R/CD-RW and external storage devices (USB, SD) 6 iPod 6 Audio Adjustments 8 Initial Settings 9 Other Functions 10 Installation Connections Installation Thank you for purchasing this PIONEER product. To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. [. . . ] Only frequencies lower than those in the selected range are outputted from the subwoofer. To cycle between the cut-off frequency and output level of the subwoofer. Adjustment range: +6 to -24 HPF SETTING (high pass filter adjustment) When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are output from the front or rear speakers. SLA (source level adjustment) SLA (Source Level Adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz. AM STEP (AM tuning step) The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. -- Place all cables away from hot places, such as near the heater outlet. -- Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. -- Never cut the insulation of the power cable of this unit in order to share the power with other devices. Turning the clock display on or off % Press /DISP OFF to turn the clock display on or off. # The clock display disappears temporarily when you perform other operations, but the clock display appears again after 25 seconds. Turning the display off and on % Press /DISP OFF and hold until the display turns off and on. # Even if the display indication is turned off, operation can be conducted. If operation is conducted while the display indication is off, display will light up for a few seconds and then turn off again. Other devices (Another electronic device in the car) Metal parts of car's body When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle's auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Perform these connections when using a subwoofer without the optional amplifier. J When using a subwoofer of 70 W (2 ), be sure to connect the subwoofer to the violet and violet/black leads of this unit. [. . . ] This unit may not operate correctly depending on the application used to encode WMA files. There may be a slight delay when starting playback of audio files embedded with image data. Since the CD side of DualDiscs is not physically compatible with the general CD standard, it may not be possible to play the CD side with this unit. Playable folder hierarchy: up to eight tiers (A practical hierarchy is less than two tiers. [. . . ]