User manual PIONEER DEH-4300UB

[. . . ] To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. The RDS (radio data system) function only operates in areas with broadcasting RDS signals for FM stations. [. . . ] Only frequencies lower than those in the selected range are outputted from the subwoofer. To cycle between the cut-off frequency and output level of the subwoofer. Cut-off frequency: 50HZ--63HZ--80HZ--100HZ --125HZ Output level: -24 to +6 SLA (source level adjustment) SLA (Source Level Adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. After selecting, perform the following procedures to set the initial setting. fM STEP (FM tuning step) Normally , the FM tuning step employed by seek tuning is 50 kHz. When AF or TA is on, the tuning step automatically changes to 100 kHz. AUTO-PI (auto PI seek) The unit can automatically search for a different station with the same programming, even during preset recall. AUX (auxiliary input) Activate this setting when using an auxiliary device connected to this unit. USB (plug and play) This setting allows you to switch your source to USB/ iPod automatically. oN ­ When a USB storage device/iPod is connected , depending on the type of device , the source is automatically switched to USB/iPod when you turn on the engine. If you disconnect your USB storage device/iPod, this unit's source is turned off. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle's auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Ground cables for this unit and other equipment (especially, high-current products such as power amps) must be wired separately. If they are not, an accidental detachment may result in a fire or malfunction. Note AUX cannot be selected unless the auxiliary setting is turned on. The sound is turned off, MUTE is displayed and no audio adjustments, except volume control, are possible. Operation returns to normal when the phone connection or the voice guidance is ended. Use of this unit in conditions other than the following could result in fire or malfunction. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. [. . . ] Russian text to be displayed on this unit should be encoded with the following character sets: !A character set other than Unicode that is used in a Windows environment and is set to Russian in the multi-language setting This unit may not operate correctly depending on the application used to encode WMA files. There may be a slight delay at the start of playback of audio files embedded with image data or audio files stored on a USB storage device that has numerous folder hierarchies. Do not leave discs or a USB storage device in any place that is subject to high temperatures. [. . . ]