User manual PIONEER DEH-3350UB

[. . . ] To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. Operating this unit Head unit Do not allow this unit to come into contact with liquids. [. . . ] If you switch to REAR-SP :SW, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to SUBWOOFER1 (subwoofer on/off setting) on the previous page). If you change this setting, subwoofer output in the audio menu will return to the factory settings. The following functions are still accessible from the unit even if the control mode is set to CTRL iPod/CTRL APP. -- Pausing -- Fast forward/reverse -- Track up/down -- Repeat play (ONE/ALL/OFF) -- Random play (shuffle) (list) to use iPod menu -- -- a to turn the iPod click wheel to the left -- b to turn the iPod click wheel to the right !When the control mode is set to CTRL iPod, operations are limited as follows: -- The function settings are not available. After selecting, perform the following procedures to set the initial setting. FM STEP (FM tuning step) The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz. After selecting, perform the following procedures to set the audio function. When the rear output and RCA output setting are SW, you cannot adjust front/rear speaker balance. The cut-off frequency and output level can be adjusted when the subwoofer output is on. Only frequencies lower than those in the selected range are outputted from the subwoofer. To cycle between the cut-off frequency and output level of the subwoofer. # You cannot create a custom illumination color when SCAN is selected. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. -- Place all cables away from moving parts, such as the gear shift and seat rails. -- Place all cables away from hot places, such as near the heater outlet. -- Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. -- Never cut the insulation of the power cable of this unit in order to share the power with other devices. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle's auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. [. . . ] Since the CD side of DualDiscs is not physically compatible with the general CD standard, it may not be possible to play the CD side with this unit. frequent loading and ejecting of a DualDisc may result in scratches on the disc. In some cases, a DualDisc may become stuck in the disc loading slot and will not eject. To prevent this, we recommend you refrain from using DualDisc with this unit. [. . . ]