User manual PIONEER DEH-1600UB

[. . . ] ователя Italiano Español Deutsch Nederlands Русский <QRD3204-A>1 Black plate (2, 1) Section 01 Before you start Before you start Thank you for purchasing this PIONEER product To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. About this unit The tuner frequencies on this unit are allocated for use in Western Europe, Asia, the Middle East, Africa and Oceania. [. . . ] 6 En <QRD3204-A>6 Black plate (7, 1) Section Using this unit Using this unit 02 Use this function when wanting to listen only to high-frequency sounds. Only frequencies higher than the high-pass filter (HPF) cutoff are output from the speakers. To cycle between the following: Cut-off frequency—Slope level 3 Turn M. System menu Important PW SAVE (power saving) is canceled if the vehicle battery is disconnected and will need to be turned back on once the battery is reconnected. When PW SAVE (power saving) is off, depending on connection methods, the unit may continue to draw power from the battery if your vehicle’s ignition doesn’t have an ACC (accessory) position. You can also change the dimmer setting by pressing and holding /DIMMER. MUTE MODE (mute mode) En 7 <QRD3204-A>7 Black plate (8, 1) Section 02 03 Using this unit Installation Using an AUX source 1 Insert the stereo mini plug into the AUX input jack. Note AUX cannot be selected unless the auxiliary setting is turned on. When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. O N Switching the display Selecting the desired text information 1 Press DISP to cycle between the following: !Use of this unit in conditions other than the following could result in fire or malfunction. If an unwanted display appears Turn off the unwanted display using the procedures listed below. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. € Disconnect the negative terminal of the battery before installation. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. € Place all cables away from moving parts, such as the shift lever and seat rails. € Place all cables away from hot places, such as near the heater outlet. € Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. € Never cut the insulation of the power cable of this unit in order to share the power with other devices. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle’s auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. [. . . ] There may be a slight delay at the start of playback of audio files embedded with image data or audio files stored on a USB storage device that has numerous folder hierarchies. Playable files: up to 15 000 Playback of copyright-protected files: Not compatible Partitioned USB storage device: Only the first partition can be played. There may be a slight delay when starting playback of audio files on a USB storage device with numerous folder hierarchies. USB storage device Playback sequence is the same as recorded sequence in the USB storage device. [. . . ]