User manual PIONEER DEH-1500UB

[. . . ] ователя Italiano Español Deutsch Nederlands Русский Section 01 Before you start Before you start Thank you for purchasing this PIONEER product To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. About this unit The tuner frequencies on this unit are allocated for use in Western Europe, Asia, the Middle East, Africa and Oceania. [. . . ] W – Select when there is a fullrange speaker connected to the rear speaker leads output and there is a subwoofer connected to the RCA output. W – Select when there is a subwoofer connected directly to the rear speaker leads output without any auxiliary amp and there is a subwoofer connected to the RCA output. REAR/REAR – Select when there is a fullrange speaker connected to the rear speaker leads output and the RCA output. If there is a full-range speaker connected to the rear speaker leads output and the RCA output is not used, you may select either REAR/SUB. Switching the dimmer setting You can adjust the brightness of illumination. You can also change the dimmer setting by pressing and holding /DIMMER. When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. F Using an AUX source 1 Insert the stereo mini plug into the AUX input jack. Note AUX cannot be selected unless the auxiliary setting is turned on. For more details, refer to AUX (auxiliary input) on the previous page. English O N ACC position No ACC position Switching the display Selecting the desired text information 1 Press DISP to cycle between the following: !Use of this unit in conditions other than the following could result in fire or malfunction. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. € Disconnect the negative terminal of the battery before installation. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. € Place all cables away from moving parts, such as the shift lever and seat rails. € Place all cables away from hot places, such as near the heater outlet. € Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. € Never cut the insulation of the power cable of this unit in order to share the power with other devices. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle’s auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. [. . . ] There may be a slight delay at the start of playback of audio files embedded with image data or audio files stored on a USB storage device that has numerous folder hierarchies. USB storage device Address any questions you have about your USB storage device to the manufacturer of the device. Do not let the USB storage device fall onto the floor, where it may become jammed under the brake or accelerator pedal. Depending on the USB storage device, the following problems may occur. [. . . ]