User manual PIONEER DEH-1350MPG

[. . . ] Operating this unit Use and care of the remote control Using the remote control 1 Point the remote control in the direction of the front panel to operate. When using for the first time, pull out the film protruding from the tray. Replacing the battery 1 Slide the tray out on the back of the remote control. Do not let the remote control fall onto the floor, where it may become jammed under the brake or accelerator pedal. [. . . ] The six strongest broadcast frequencies are stored in the order of their signal strength. LOCAL (local seek tuning) Local seek tuning lets you tune in to only those radio stations with sufficiently strong signals for good reception. FM: LOCAL 1--LOCAL 2--LOCAL 3--LOCAL 4 AM: LOCAL 1--LOCAL 2 The highest level setting allows reception of only the strongest stations, while lower levels allow the reception of weaker stations. Depending on the version of iTunes used to write MP3 files to a disc or media file types, incompatible text stored within an audio file may be displayed incorrectly. After selecting, perform the following procedures to set the function. After selecting, perform the following procedures to set the initial setting. FM (FM tuning step) The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz. 50 (50 kHz)--100 (100 kHz) AM (AM tuning step) The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. When using the tuner in North, Central or South America, reset the tuning step from 9 kHz (531 kHz to 1 602 kHz allowable) to 10 kHz (530 kHz to 1 640 kHz allowable). Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. -- Place all cables away from moving parts, such as the gear shift and seat rails. -- Place all cables away from hot places, such as near the heater outlet. -- Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. -- Never cut the insulation of the power cable of this unit in order to share the power with other devices. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle's auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Use speakers over 50 W (output value) and between 4 W to 8 W (impedance value). When installing this unit or power amp (sold separately), make sure to connect the ground wire first. Ensure that the ground wire is properly connected to metal parts of the car's body. The ground wire of the power amp and the one of this unit or any other device must be connected to the car separately with different screws. [. . . ] Please refer to the information from the disc manufacturer for more detailed information about DualDiscs. Folder selection sequence or other operation may differ depending on the encoding or writing software. Only the first 32 characters can be displayed as a file name (including the file extension) or a folder name. This unit may not operate correctly depending on the application used to encode WMA files. [. . . ]