User manual PIONEER CX-J410

[. . . ] RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 5 amps and that it is approved by ASTA or BSI to BS1362. [. . . ] A DJ system like the one shown on the diagram below can be achieved by combining this unit with a DJ player and peripheral equipment. What's in the box Power cable Warranty card Operating instructions (this document) Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections. refer to the operating instructions for the component to be connected. Connect the power cord after all the connections between devices have been completed. Connect to an analog player or other phono level (MM cartridge) output device. The fader start function can only be used when connected to a Pioneer DJ player. 2 A portable audio device can be connected using an RCA pin - mini-plug (Ø 3. Two sets of audio signals can be adjusted separately for basic DJ mixing (page 9). B CD, PHONO (input selector switch) c TRIM d HI, MID, LOW e Master level indicator f Channel level indicator g Channel fader h FADER START The sound being input to this unit can be checked over headphones (page 11). DJ performances can be recorded onto and played from USB devices (page 12). Effects can be applied to the sound output from [MASTER OUT 1, 2] (page 11). This adjusts the balance of the monitor volume between the sound output from the [MASTER OUT 1, 2] terminals (the sound of [CH-1]) and the sound of [CH-2]. While checking the sound over the headphones, adjust the tempo of [CH-2] track to match the tempo of [CH-1] track. If you set the crossfader back to the original position, the player instantaneously returns to the cue point already set and pauses playback (back cue). 7 While moving the [CH-2] 2 channel fader to the back, move the [CH-1] 1 channel fader to the front. While checking the sound output from the speakers, operate the channel faders to substitute the sound of [CH-1] with the sound of [CH-2]. Mixing is completed once only the [CH-2] sound is being output from the speakers. When a button that is flashing is pressed again, the effect is turned off. Cut from the sound of the Right: The low range (bass track's rhythm section to drum, etc. Left: The sound is crushed and an effect as if the high range was gradually cut is achieved. Right: The sound is crushed and an effect as if the low range was gradually cut is achieved. This operation is not necessary to monitor the master channel sound (the sound output from the [MASTER OUT 1, 2] terminals). [. . . ] (page 7) Connect this unit to the audio output terminal of a DJ player with an audio cable. (page 11) Before recording, adjust [MASTER LEVEL] so that the orange indicator on the master level indicator lights at the peak level. (page 9) Before recording, adjust [TRIM] so that the orange indicator on the channel level indicator lights at the peak level. (page 12) This unit supports such USB mass storage class USB devices as external hard disks and portable flash memory devices. [. . . ]