User manual PIONEER CU-RF100-U

[. . . ] To prevent a fire or shock hazard, do not place any container filled with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain or moisture. Any failure due to use for other than household purposes (such as long-term use for business purposes in a restaurant or use in a car or ship) and which requires repair will be charged for even during the warranty period. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Note 1 This function is only valid when RECEIVER is set to IR MODE at the remote control's IR/RF SELECT setting (page 7). 3 Press the input function button for the component you want to control, then press ENTER. when assigning preset codes to TV CONTROL , set the remote control operation selector switch to TV here. The remote display shows the component you want to control (for example DVD or TV). 1 4 Use / to select the first letter of the brand name of your component, then press ENTER. This should be the manufacturer's name (for example, P for Pioneer). 5 Use / to select the manufacturer's name from the list, then press ENTER. 6 Use / to select the proper code from the list, then try using this remote with your component. 2 To try out the remote control, switch the component on or off (into standby) by pressing SOURCE. If it doesn't seem to work, select the next code from the list (if there is one). If you can't find or properly enter a preset code, you can still teach the remote individual commands from another remote control (see Programming signals from other remote controls below). If the preset code for your component is not available, or the available preset codes do not operate correctly, you can program signals from the remote control of another component. This can also be used to program additional operations (buttons not covered in the presets) after assigning a preset code. The remote display prompts you for the component you want to control (for example DVD or TV). 3 Press the input function button for the component you want to control, then press ENTER. And Canadian models only: Note, however, that Sirius is pre-assigned to OPTION 1, XM to OPTION 2, and if other preset codes are assigned, Sirius and XM operations can no longer be performed. If you accidentally assign other codes to one of these buttons, it is possible to reset that button only (see Resetting the input assignment of one of the input function buttons on page 16). When using a Pioneer flat panel TV released prior to summer 2005, please select preset code 644. 3 The remote can store about 200 preset codes (this has been tested with codes of Pioneer format only). The TV CONTROL buttons (TV, TV VOL +/­, TV CH +/­, MUTE and INPUT) can only be learned after the operation selection switch is set to TV. 4 Point the two remote controls towards each other, then press the button that will be doing the learning on this receiver's remote control. PRESS KEY lights continuously to indicate the remote is ready to accept a signal. [. . . ] There are obstacles between the remote control and the receiver's remote sensor. ⷠDirect sunlight or fluorescent light is shining onto the remote sensor. If you think that there is something wrong with this remote control unit, check the points below. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer authorized independent service company to carry out repair work. [. . . ]