User manual PIONEER CU-AV200

[. . . ] RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 5 amps and that it is approved by ASTA or BSI to BS1362. [. . . ] Connect the power cord after all the connections between devices have been completed. Connect the power cord after all the connections between devices have been completed. When connected to a Pioneer DJ mixer using the control cord (included), operations such as starting playback on this unit can be controlled using the DJ mixer's fader (page 21). The fader start function can only be used when connected to a Pioneer DJ mixer. Using the relay play function Relay playback on two DJ players is possible when the [CONTROL] terminals on this unit and the other Pioneer DJ player are interconnected using a control cord (page 21). When connected to a computer by USB cable, the DJ software can be operated with this units (page 21). The sound of music files playing on the computer can be output from this unit (page 10). These controls can be used for such basic DJ player operations as playing discs, setting cue/loop points and operating the jog dial (page 16). When [BPM LOCK] is used, the playing speeds of two tracks can be matched easily (page 21). The characters that can be displayed are letters A to Z, numbers 0 to 9 and certain symbols. Insert the disc horizontally into the disc insertion slot in the main unit's front panel. When pressed twice in a row, playback returns to the beginning of the previous track. When auto cue is turned on, the set searches for the beginning of the track and pauses there (page 17). The auto cue level setting remains in the memory, even when the power is turned off. The acoustic pressure level identified as a silent section with the auto cue function can be selected from eight levels. â­36 dB , ­42 dB , ­48 dB , ­54 dB , ­60 dB , ­66 dB , ­72 dB and ­78 dB !The auto cue level setting remains in the memory, even when the power is turned off. The auto cue level can be changed using one of the procedures described below. When a new cue point is set, the previously set cue point is canceled. Using [DISPLAY (UTILITY)] j 1 2 3 Press [DISPLAY (UTILITY)] j for at least 1 second. Using [TIME MODE (AUTO CUE)] i 1 Press [TIME MODE (AUTO CUE)] i for at least 5 seconds. The position at which the button was pressed is set as the new cue point. [. . . ] Always place discs in their cases and store them vertically, avoiding hot, humid places, places exposed to direct sunlight and extremely cold places. For tough dirt, apply some water to a soft cloth, wring out thoroughly, wipe off the dirt, then wipe off the moisture with a dry cloth. Also note that rental discs often have labels attached to them, and the label's glue may have oozed out. Check that there is no glue around the edges of such labels before using rented discs. [. . . ]