User manual PIONEER CT-F600

[. . . ] A damaged power cord can cause a fire or give you an electrical shock. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement. The basic layout (see the open-spread page example below) features common illustrations together with four columns of instructions, each in a different language as shown. The wires in this mains lead are coloured in accordance with the following code: Blue : Neutral Brown : Live If the plug provided is unsuitable for your socket outlets, the plug must be cut off and a suitable plug fitted. [. . . ] To avoid adversely affecting the receiver and speakers, be sure to set the volume level to the minimum. For further details, refer to the operating instructions accompanying your head demagnetizer. Tapes recorded using Dolby noise reduction should always be played back with the noise reduction system turned ON. The NR system is turned ON and OFF alternately with each press of the button as shown. : : : Single side play (playback stops after one side) Playback stops after completion of playback in the 2 direction. Continuous repeat playback of both sides, up to a maximum of 16 tape sides, after which the cassette deck stops automatically. Lecture répétée et continue des deux faces jusqu'à un maximum de 16 faces, puis arrêt automatique de la platine-cassette. ¶ Each time the play/direction (2 3) button on the remote control unit is pressed, the direction of travel changes alternately between side A and side B as shown below: 3 (side A) Ô 2 (side B) ¶ When loading the cassette tape in the cassette tray, if the cassette is set with side A facing UP, the "forward" direction (3) will correspond to side A and the "reverse" direction (2) will correspond to side B. To fast forward or fast reverse the tape ¶ Press when the tape is stopped. To search for a particular track (Music Search) While the cassette deck is in the playback mode, press either the 1 or ¡ button ( 4 or ¢ button on the remote control unit). ¶ When the remote control unit is used, music search can also be performed from the stop mode. NOTES: ¶ When the tape cassette comes to the end of side A and recording switches to side B, if CD playback is in the middle of a track, that entire track will be recorded anew on side B. If the CD player's repeat function is turned ON, repeat playback will be canceled. Function to play back a cassette tape on the CD tuner deck while automatically recording onto another cassette tape. Each time the button is pressed, the function turns ON and OFF alternately. : Recording is started from side A (3 direction), recording continues to side B (2 direction). ¶ Playback always begins automatically when a playback-only MD is inserted. Use the 4, ¢ buttons to select the track you wish to record (1-track A. With the MiniDisc stopped, confirm that the display shows the total number of tracks. If the total number of tracks is not displayed, press the stop (7) button on the CD MD tuner. ¶ When this procedure is used to select a MiniDisc track, the One-Track A. Recording can also be stopped by pressing the stop (7) button on the CD MD tuner. [. . . ] Turn the JOG dial to set the desired hour, then press the TIMER button (Press ENTER button when using CD MD Tuner). Turn the JOG dial to set the desired minutes, then press the TIMER button (Press ENTER button when using CD MD Tuner). Turn the JOG dial to select "OP TAPE" (Turn the JOG dial to select "TAPE REC" when using CD MD tuner). ¶ In the case of the CD Tuner Deck, if TAPE REC is selected at this point, recording will be performed onto the cassette tape loaded in the CD Tuner deck. [. . . ]