User manual PIONEER CS-R500 service manual

[. . . ] "CLASS 1 LASER PRODUCT" This product contains a laser diode of higher class than 1. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. Always keep the volume low enough so that you can hear sounds from outside the vehicle. If the battery is disconnected or discharged, the preset memory will be erased and must be reprogrammed. [. . . ] You can operate the preprogrammed functions for each source by using PGM on the remote control. % Press PGM to turn pause on when selecting the following sources: You can use this unit to control an interface adapter for iPod, which is sold separately. Play time-- : artist name and : song title -- : artist name and : album name-- : album name and : song title-- : song title and play time # If the characters recorded on the iPod are not compatible with this unit, those characters are not displayed. You can scroll the text information to the left by pressing and holding DISP/SCROLL. While iPod is connected to this unit, PIONEER (or (check mark)) is displayed on the iPod. When the ignition switch is set to ACC or ON, the iPod's battery is charged while the iPod is connected to this unit. While the iPod is connected to this unit, the iPod cannot be turned on or off. Before connecting the dock connector of this unit to the iPod, disconnect the headphones from the iPod. The iPod is turned off about two minutes after the ignition switch is set to OFF. CDBTB100) to this unit, you can control Bluetooth audio players via Bluetooth wireless technology. Play mode and Pause operations are basically the same as that of the built-in CD player. Note Before you can use audio players you may need to enter the PIN code into this unit. If your player requires a PIN code to establish a connection, look for the code on the player or in its accompanying documentation. Playing songs on a Bluetooth audio player CDBTB100), you can connect a cellular phone featuring Bluetooth wireless technology to this unit for hands-free, wireless calls, even while driving. The level shown on the indicator may differ form the actual signal level. 3 User number indicator Shows the registration number of the cellular phone. 4 Battery strength indicator Shows the battery strength of cellular phone. The level shown on the indicator may differ from the actual battery strength. If the battery strength is not available, nothing is displayed in the battery strength indicator area. 5 Incoming call notice indication Shows when an incoming call has been received and not checked yet. This entails establishing a Bluetooth wireless connection between this unit and your phone, registering your phone with this unit, and adjusting the volume level. 1 Connection For detailed instructions on connecting your phone to this unit via Bluetooth wireless technology, refer to Connecting a cellular phone on page 43. [. . . ] We recommend that you set the iPod Equalizer to off, before connecting to this unit. Even if you set Repeat to off on the iPod, Repeat is automatically changed to All when connecting the iPod to this unit. 22 W × 4 (50 Hz to 15 000 Hz, 5 % THD, 4 W load, both channels driven) Load impedance . Note Specifications and the design are subject to modifications without notice due to improvements. [. . . ]