User manual PIONEER CLD-V202

[. . . ] Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e. If the AC plug of this unit does not match the AC outlet you want to use, the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. if connected to an AC outlet , the cut-off plug can cause severe electrical shock. [. . . ] Please keep in mind the following when using the remote control: · Make sure that there are no obstacles between the remote and the remote sensor on the unit. Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit's remote sensor. Remote controllers for different devices can interfere with each other. Replace the batteries when you notice a fall off in the operating range of the remote. Use within the operating range in front of the remote control sensor on the unit, as shown. The Auto Multi-Channel Acoustic Calibration (MCACC) setup measures the acoustic characteristics of your listening area, taking into account ambient noise, speaker size and distance, and tests for both channel delay and channel level. After you have set up the microphone provided with your system, the system uses the information from a series of test tones to optimize the speaker settings and equalization for your particular room. cAUTION · The test tones used in the Auto MCACC Setup are output at high volume. important · When using HTP-FS510 and HTP-SB510 models, always use the Auto MCACC setup function. If this setup is not performed, various problems may occur, including an inability to hear screen dialogue, or to hear sound from the surround channel. The OSD will not appear if you have connected using the HDMI output to your TV. check for household appliances (air conditioner , fridge , fan , etc. ), that may be affecting the environment and switch them off if necessary. If there are any instructions showing in the front panel display, please follow them. If this seems to be happening, switch off the TV when doing the Auto MCACC Setup. Be sure to disconnect the microphone from this unit upon completion of the Auto MCACC setup. The settings made in the Auto MCACC Setup should give you excellent surround sound from your system, but it is also possible to adjust these settings manually using the System Setup menu (starting on page 72). Note 1 The subwoofer distance setting may be farther than the actual distance from the listening position. This setting should be accurate (taking delay and room characteristics into account) and generally does not need to be changed. Procedures for listening to audio from a radio or connected other component. On this system, it is possible to switch the input signals for the different inputs as described below. When DIGITAL (C1/O1/O2) or HDMI (H) is selected and the selected audio input is not provided, A (analog) is automatically selected. [. . . ] In this case, connect using the composite video jack between source and system. If video images do not appear on your TV, try adjusting the resolution, DeepColor or other setting for your component. To output signals in DeepColor, use an HDMI cable (High Speed HDMI® Cable) to connect this system to a component or TV with the DeepColor feature. The OSD will not appear if you have connected using the HDMI output to your TV. [. . . ]