User manual PIONEER CDJ-400

[. . . ] Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory K015 En drawings. RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Do not attempt to press a disc back into the slot when the [EJECT] indicator appears. Pressing a disc back into the slot while the [EJECT] indicator appears may cause the player to stop. In this case, press the EJECT button again and wait until the [EJECT] indicator goes out before reinserting the disc. If the EJECT button does not function or the disc cannot be removed, pushing the pin provided into the forced ejection hole on the front panel will enable the disc to be removed. When performing forced ejection, be sure to follow the precautions below. 1 Be sure to turn OFF the power of the CD player, and check that the disc has stopped rotating. It takes about 60 seconds for the disc to stop rotating after the power has been turned OFF. If forced ejection is performed while the disc is rotating; ÷ As the disc will be ejected outside the CD player rotating, it may hit your finger and cause injuries. As the disc will be rotating with the clamp unstable, it may be scratched. For the above reasons, never attempt to eject the disc forcibly while it is rotating. The provided pin is found in a groove in the bottom surface of the player. When the provided forced eject pin is inserted fully into the forced eject hole on the front panel, the loaded disc is ejected about 5 mm to 10 mm from the loading slot, making it possible to remove it by hand. ¶ When inserting a disc, keep the label-side up, and insert only one disc into the disc loading slot located in the front panel of the unit. 13) ¶ If a CD-ROM with no MP3 file in the first session is inserted, the display will read [NO TRACK] and the CD-ROM will not be played. ¶ When a USB memory device is connected to the USB port, press the SOURCE SELECT button to alternate between playback from disc (CD) or files on the USB memory. The non-recorded portion at the beginning of the displayed track will be skipped and playback will begin instantly. When the first track's playback ends, the player will automatically search for the beginning of the next track. The indicator on the CUE button will light, the PLAY/PAUSE button (6) indicator will flash and the player will then wait for the PLAY/ PAUSE button (6) to be pressed before beginning playback of the next track. When a disc is loaded or track search/track change is performed, this function automatically sets the cue point (P. When the Auto Cue function is turned off, playback will begin automatically from the first track. ¶ When Auto Cue function is turned off, playback will continue after the first track has been played, with all subsequent tracks being played in sequence. Hold down the AUTO CUE button again to turn the auto cue function off. [. . . ] If the point cannot be found within 10 seconds, the cue point is set at the track's beginning. In the case of MP3, loop cannot be performed if no loop-in point is located within the currently playing track. The disc rotation stops automatically if no operation has been performed for 100 minutes or more in pause mode. Back cue function cannot be carried out even though the CUE button is pressed in playback mode. [. . . ]