User manual PIONEER BP-320

[. . . ] "CLASS 1 LASER PRODUCT" This product contains a laser diode of higher class than 1. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. Always keep the volume low enough so that you can hear sounds from outside the vehicle. If the battery is disconnected or discharged, the preset memory will be erased and must be reprogrammed. [. . . ] Before connecting the dock connector of this unit to the iPod, disconnect the headphones from the iPod. The iPod is turned off about two minutes after the ignition switch is set to OFF. Operations to control an iPod with this unit is designed to be as close to the iPod as possible to make operation and song search easy. Depending on the number of files in the iPod, there may be a delay when displaying a list. If the characters recorded on the iPod are not compatible with this unit, those characters are not displayed. The list is displayed starting from the selected letter of the alphabet. # You can start playback throughout the selected category by pressing and holding MULTI-CONTROL. You can also perform this operation by pushing and holding MULTI-CONTROL right. # If the characters recorded on the iPod are not compatible with this unit, those characters are not displayed. You can scroll the text information to the left by pressing and holding DISP/BACK/SCRL. # To return to the previous category (one level higher), press DISP/BACK/SCRL. SLOWER ­ Playback slower than normal speed Turn MULTI-CONTROL to switch between the audio functions in the following order. FADER/BALANCE (balance adjustment)-- PRESET EQUALIZER (equalizer recall)-- EQ SETTING 1 (equalizer adjustment)-- EQ SETTING 2 (equalizer fine adjustment)-- LOUDNESS (loudness)--SW SETTING 1 (subwoofer on/off setting)--SW SETTING 2 (subwoofer setting)--HIGH PASS FILTER (high pass filter)--BASS BOOST (bass boost)-- SRC LV ADJUST (source level adjustment) 4 Press MULTI-CONTROL to display the setting mode of each function. If you do not operate functions within about 30 seconds, the display automatically returns to the ordinary display. You can change the fader/balance setting so that it can provide the ideal listening environment in all occupied seats. Front/rear speaker balance can be adjusted between FAD F15 and FAD R15. Left/right speaker balance can be adjusted between BAL L15 and BAL R15. # You can also perform the same operations by pushing MULTI-CONTROL up or down. When the subwoofer controller setting is PREOUT:REAR, you cannot switch to SW SETTING 1 (subwoofer on/off setting). You can select the SW SETTING 2 only when subwoofer output is turned on in SW SETTING 1. There are six stored equalizer curves which you can easily recall at any time. Press MULTI-CONTROL repeatedly to switch the segment in the following order: L (low)--M (mid)--H (high) 4 Turn MULTI-CONTROL to adjust the level of the equalization band. [. . . ] Do not use an adapter which has metal parts other than the connectors exposed. Do not try to force an SD memory card into the SD card slot as the SD memory card or this unit may be damaged. It is dangerous to press the SD memory card and release your finger immediately as the SD card may shoot out of the slot and hit you in the face, etc. There may be a slight delay when starting playback of audio files encoded with image data. [. . . ]