User manual PIONEER BDR-202

[. . . ] NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] POWER - Before installing the unit on the system, be sure to turn off power on the system and remove the power cord from the AC outlet. READ INSTRUCTIONS - Read all safety and operating instructions before the Drive is operated. RETAIN INSTRUCTIONS - Retain the safety and operating instructions for future reference. POWER SOURCES - Operate this product from the type of power source indicated on the marking label. If you are not sure of the type of power available, consult Authorized Pioneer Dealer. OBJECT AND LIQUID ENTRY - Never push objects of any kind into this product. Touching dangerous voltage points may cause a short resulting in fire or electric shock. CONDENSATION - Moisture will form in the operating section of the product causing performance to be impaired if it is brought from cool surroundings into a warmer environment. If you are moving the unit to a location with a warmer temperature, let the product stand for 1-2 hours in the new location before turning it back on. Opening or removing covers may expose you to dangerous voltage or other hazards. Remove dust or lint from the disc with a soft cloth by wiping from the inside to the outside edge rather than in a circular motion. Do not use record-cleaning or anti-static agents as the solutions may cause damage to a disc. Always be sure to store your discs in proper disc storage cases when not in use, and always be sure to check for dirt or dust on discs (especially on the recording side) before use. 25inch Half-Height built in type • LCD Tilt Servo Mechanism • Horizontal/Vertical orientation available • Low vibration Mechanism by DRA system Disc Format (Read/Write) • BD-ROM single layer/dual layer • Single layer BD-R(Version 1. 1) • DVD single layer/dual layer /120 mm disc /80 mm disc • DVD-R (In case of write, 650nm disc for General only. 2(RAM2 Read Only)) (Non-Cartridge) • CD-ROM Mode 1 • CD-ROM XA Mode2 (form 1, form2) • Photo CD (single and multiple session) • CD-DA • CD-Extra (CD PLUS) • Video CD • CD Text • CD-R • CD-RW, HS CD-RW, US CD-RW, US+ CD-RW Notes: • Specific application program(s) that support above format(s) required. € Supported media required for specific BD, DVD & CD writing speeds. INTERFACE FRONT VIEW VUE AVANT INTERFACE SCHNITTSTELLE VORDERANSICHT 1 Loch für erzwungenen Auswurf 1 1 Forced Ejection Hole Insert a stiff rod into the hole and push to eject the tray when the tray doesn’t unload by pressing the Eject button. In the normal operation, the eject button should be used to unload the tray. Make sure the power of the drive is turned off and wait more than one minute till the disc rotation is stopped when access the eject hole. [. . . ] 4 When affixing is required, please refer to the instruction manual for the computer. When slide rails are required, please contact your shop or the computer manufacturer. When connecting the power cable from the personal computer, pay close attention to the shape and polarity of the cable. When connecting the Serial ATA interface cable, pay close attention to the shape and polarity of the cable. [. . . ]