User manual PIONEER BDP-LX71

[. . . ] Operating Instructions Blu-ray Disc PLAYER Thank you for buying this Pioneer product. Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the instructions, put them away in a safe place for future reference. IMPORTANT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] Press VIDEO SELECT to switch the terminal from which the video signals are output. Depending on the player's output video resolution, the picture may not be displayed at all or displayed properly. Use OUTPUT RESOLUTION to switch to a resolution at which the picture is displayed properly (page 24). Is the player set in a humid place? Picture freezes and the front panel and remote control buttons stop working. No picture is displayed or the Is the video cable properly connected?Is the input setting on the connected TV or AV receiver or amplifier right?Is the output video resolution properly set? Is the player connected with an HDMI cable other than a High Press while pressing on the player's front panel to restore Speed HDMITM cable (with a Standard HDMITM cable)?There are some BDs for which the picture will only be output when connected by HDMI cable. Does the connected TV support the frame rate of the video signal being output by the player?If the picture is not displayed when playing a disc with a frame rate that is not supported, the picture will not be displayed even when playback is stopped. In this case, use the procedure below to switch the frame rate of the video signals output from the player. Then, press OPEN/CLOSE while pressing on the player's front panel to switch to a frame rate supported by the connected TV. Set NTSC on PAL TV properly (page 41). Is NTSC on PAL TV properly set? 51 En 07 Problem Picture is stretched. Aspect ratio cannot be switched. Check Is the TV's aspect ratio properly set?Is 4:3 Video Out properly set? Remedy Read the TV's operating instructions and set the TV's aspect ratio properly. · When video signals with a resolution of 1080/50i, 1080/50p, 720/50p, 1080/24p, 1080/60i, 1080/60p or 720/60p are being output from the HDMI OUT terminal or the COMPONENT VIDEO output terminals, they may be output with an aspect ratio of 16:9 even if TV Aspect Ratio is set to 4:3 (Standard) (page 24). · This player supports Macrovision analog copy protection technology. With some TVs (such as with built-in video deck), the picture will not be displayed properly when the copy protected DVD title is played. · If the player and TV are connected via a DVD recorder/video deck, etc. , the picture will not be displayed properly due to analog copy protection. With some content protected discs, it may not be possible to output the video signals from the VIDEO output terminals, the S-VIDEO output terminal or the COMPONENT VIDEO output terminals. In this case, connect using an HDMI cable (page 14). Sound and picture are not synchronized. Picture is dark. Is Output Terminal Priority properly set? No picture is displayed or picture is not output in high definition when playing BDs. No sound is output. Is the disc dirty? No sound is output during slow motion play and forward and reverse scanning. Clean the disc (page 59). Is the player properly connected to the other components (AV · Check that you connect the player to the audio output receiver or amplifier, etc. )? [. . . ] For software which is copyrighted by the Free Software Foundation, write to the Free Software Foundation; we sometimes make exceptions for this. Our decision will be guided by the two goals of preserving the free status of all derivatives of our free software and of promoting the sharing and reuse of software generally. BECAUSE THE LIBRARY IS LICENSED FREE OF CHARGE, THERE IS NO WARRANTY FOR THE LIBRARY, TO THE EXTENT PERMITTED BY APPLICABLE LAW. EXCEPT WHEN OTHERWISE STATED IN WRITING THE COPYRIGHT HOLDERS AND/OR OTHER PARTIES PROVIDE THE LIBRARY "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. [. . . ]