User manual PIONEER AVX-P7000CD annexe 1

[. . . ] ⷠRefer to the owner's manual for details on connecting the power amp and other units, then make connections correctly. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. ⷠRoute and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake, and seat rails. [. . . ] Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. ⷠDon't pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short. ⷠNever feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. When replacing fuse, be sure to use only fuse of the rating prescribed on the fuse holder. ⷠIf the RCA pin jack on the unit will not be used, do not remove the caps attached to the end of the connector. ⷠDo not place the display in a position where it will impede the driver's visibility or affect the operation of your vehicle's air bags. ⷠIf installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. This unit can be properly installed either from "Front" (conventional DIN Front-mount) or "Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. 7 When the installation space is not very deep When installing in a shallow space, secure with side brackets (small). In this case, stick conceal tape on parts that protrude from the dashboard. Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. [. . . ] Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. Installation using the screw holes on the side of the unit Fastening the unit to the factory radio mounting bracket. Select a position where the screw holes of the bracket and the screw holes of this product become aligned (are fitted), and tighten the screws at 2 places on each side. [. . . ]