User manual PIONEER AVH-P6800DVD

[. . . ] Where such regulations apply, they must be obeyed and this unit's DVD features should not be used. <ENGLISH> Note: • This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recreational vehicle, truck, or bus, check the battery voltage. € To avoid shorts in the electrical system, be sure to disconnect the ≠ battery cable before beginning installation. [. . . ] € When an external power amp is being used with this system, be sure not to connect the blue/white lead to the amp’s power terminal. Likewise, do not connect the blue/white lead to the power terminal of the auto-antenna. € To avoid short-circuit, cover the disconnected lead with insulating tape. There is a possibility of a shortcircuit if the leads are not insulated. € To prevent incorrect connection, the input side of the IP-BUS connector is blue, and the output side is black. € This unit cannot be installed in a vehicle that does not have an ACC (accessory) position on the ignition switch. Please ground this lead separately from the ground of high-current products such as power amps. If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire. € Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied manuals of both products and connect cords that have the same function. printed in Japan Imprimé au Japon <CRD4074-A> RE <KNNNF> <06C00000> T T Fig. 1 Connecting the Units Connecting the power cord 20 cm Note: Depending on the kind of vehicle, the function of 3* and 5* may be different. 1* 3* 2* Blue This product This product 5* 4* IP-BUS cable Multi-CD player (sold separately) Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. 15 cm AUX input jack Subwoofer output or non fading output (SUBWOOFER OUTPUT or NON-FADING OUTPUT) 23cm <ENGLISH> When connecting to separately sold power amp Power amp (sold separately) Power amp (sold separately) Cap (1*) When not using this terminal, do not remove the cap. Yellow (3*) Back-up (or accessory) Connect leads of the same color to each other. Fuse holder (10 A) Power amp (sold separately) Yellow (2*) To terminal always supplied with power regardless of ignition switch position. Note: • The position of the parking brake switch depends on the vehicle model. This lead must be connected to the power supply side of the parking brake switch. DEQ-P6600) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). Parking brake switch Note : When you connect the multi-channel processor to this unit, a separately sold power amp must be connected to the multi-channel processor. Note : Change the initial setting of this product (refer to the Operation Manual). Front speaker ≠ + ≠ Rear speaker Left + Subwoofer ≠ ≠ ≠ ≠ + Ground side ISO connector Note: In some vehicles, the ISO connector may be divided into two. [. . . ] € Use only the parts included with the unit to ensure proper installation. € Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. € Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop. € Do not install the display where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. [. . . ]