User manual PIONEER AVH-P4000DVD INSTALLATION MANUAL

[. . . ] € Make sure that wires will not interfere with moving parts of the vehicle, such as the gearshift, parking brake or seat sliding mechanism. 2 Connecting the units English Note • This unit cannot be installed in a vehicle without ACC (accessory) position on the ignition switch. ACC OF OF F O N F O N ACC position No ACC position • Use this unit in other than the following conditions could result in fire or malfunction. € To prevent short-circuit, overheating or malfunction, be sure to follow the directions below. [. . . ] 5 m This product 20 cm Multi-CD player (sold separately) iPod with Dock connector Wired remote input Hard-wired remote control adaptor can be connected (sold separately). , CD-I200) (sold separately) 5 Connecting the units Connecting the power cord Note: Depending on the kind of vehicle, the function of 3* and 5* may be different. 1* 3* 2* Antenna input Fuse (10 A) 5* 4* This product Connect leads of the same color to each other. Yellow (3*) Back-up (or accessory) Yellow (2*) Connect to the constant 12 V supply terminal. Fuse resistor ISO connector Note: In some vehicles, the ISO connector may be divided into two. , DEQ-P6600) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). Speaker leads White: White/black: Gray: Gray/black: Green: Green/black: Violet: Violet/black: Front left  Front left  Front right  Front right  Rear left  or subwoofer  Rear left  or subwoofer  Rear right  or subwoofer  Rear right  or subwoofer  6 Connecting the units English Yellow/black If you use equipment with Mute function, wire this lead to the Audio Mute lead on that piece of equipment. The position of the parking brake switch depends on the vehicle model. This lead must be connected to the power supply side of the parking brake switch. The pin position of the ISO connector will differ depending on the type of vehicle. notes: · Change the initial setting of this unit (refer to the Operation Manual). When using a subwoofer of 70 W (2 Ω) , be sure to connect with Violet and Violet/black leads of this unit. 7 Connecting the units When connecting to separately sold power amp This product Power amp (sold separately) Power amp (sold separately) Front output Rear output or subwoofer output Connect with RCA cables (sold separately) Blue/white Connect to system control terminal of the power amp (max. The pin position of the ISO connector will differ depending on the type of vehicle. , DEQ-P6600) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). When you connect the multi-channel processor to this unit, refer to multi-channel processor’s installation manual for the connection method. left Right  Front speaker        Front speaker Rear speaker or Subwoofer Rear speaker or Subwoofer Note: · Change the initial setting of this unit (refer to the Operation Manual). 8 Connecting the units When connecting with a rear view camera When this product is used with a rear view camera, it is possible to automatically switch from the video to rear view image when the gear shift is moved to REVERSE (R). € The rear view camera function is to be used as an aid for backing into a tight parking spot. € Objects in the rear view may appear closer or more distant than they actually are. This connection enables the unit to sense whether the car is moving forwards or backwards. It is necessary to set CAMERA POLARITY properly in SYSTEM MENU when connecting the rear view camera. [. . . ] (Install this unit as firmly as possible using the top and bottom tabs. Rubber bush Double-ended screw Before installing this unit • Remove the holder. English Position the unit so that its screw holes are aligned with the screw holes of the bracket, and tighten the screws at 3 or 4 locations on each side. Trim ring Installation using the screw holes on the side of the unit 1. [. . . ]