User manual PIONEER AVD-W6210

[. . . ] Pay close attention to all warnings in this manual and follow the instructions carefully. Never allow others to use the system until they have read and understood the operating instructions. Do not install the display where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including airbags, or (iii) impair the driver's ability to safely operate the vehicle. As with any accessory in your vehicle's interior, the display should not divert your attention from the safe operation of your vehicle. [. . . ] To view videos by a VCR, DVD player or a back-up camera connected to the hide-away unit. Each press of the 2 or 3 button selects the source in the following order: [OFF] = [ON] = [BACK-UP CAM] = Exit to [OFF] Note: Using a commercially available back-up camera with the proper setting, this product automatically switches to the back-up camera image when the gear shift is moved to the REVERSE (R) position. For more information, consult your dealer or the nearest authorized Pioneer service facility. Users may connect the AV IN2 input with "REVERSE-GEAR SIGNAL INPUT" only to a back-up camera. Users must not connect any other devices to the AV IN2 input with "REVERSE-GEAR SIGNAL INPUT". [BATTERY]: When the gear shift is moved to the REVERSE (R) position, and the polarity of the connected lead wire (refer to page 29) is positive. [GND]: When the gear shift is moved to the REVERSE (R) position, and the polarity of the connected lead wire (refer to page 29) is negative. verify that the back-up camera image appears on the screen when the gear shift is in the REVERSE (R) position. To return to the previous screen, move the gear shift in any position besides REVERSE (R) or just press the NAVI/AV button. Operating temperature range: ­10 to +50 °C Storage temperature range: ­20 to +80 °C At temperatures higher or lower than the operating temperature range, the display may not operate normally. The LCD screen of this product is exposed to improve view ability in the vehicle. Never touch the screen with anything besides your finger when operating the Touch Panel functions. If the display is near the vent of an air conditioner when it is deployed, make sure that air from the air conditioner is not blowing on it. Heat from the heater may break the LCD screen, and cool air from the cooler may cause moisture to form inside the display resulting in possible damage. Also, if the display is cooled down by the cooler, the screen may become dark, or the life span of the small fluorescent tube used inside the display may be shortened. Small black dots or white dots (bright dots) may appear on the LCD screen. These are due to the characteristics of the LCD screen and do not indicate a problem with the display. At low temperatures, the LCD screen may be dark for a while after the power is turned ON. When removing dust from the screen or cleaning the display, first turn the system power OFF, then wipe with a soft dry cloth. A small fluorescent tube is used inside the display to illuminate the LCD screen. * The fluorescent tube is an expendable part and has a limited service life. * The fluorescent tube should last for approximately 10, 000 hours, depending on operating conditions. [. . . ] Use of this product is subject to any government laws regarding placement or use. PIONEER does not accept any liability for any problems, damage or loss incurred as a result of the product being used with an incorrect setting or in violation of any government laws. To ensure proper installation, use the supplied parts in the manner specified. If any parts other than the supplied ones are used, they may damage internal parts of the unit or they may work loose and the unit may come off. [. . . ]