User manual PHILIPS SRU5108

[. . . ] However, if you miss certain functions, this remote control can `learn' these functions from the original remote control. Please carefully read this user manual to become familiar with your Philips universal remote control. To fully benefit from the support that Philips offers, register your product at www. ReplayTV guides and menus or on-screen guide menus used by some Satellite systems). [. . . ] You can set all devices to use the Volume / Mute buttons of a single device without needing to change to that device mode. 1 Press and hold the SETUP button until the red light indicator turns on, then release the button. 2 Press and hold the MUTE button until the red light indicator flashes off, then release the button. ) for Volume / Mute control, the red light indicator flashes then remains lit. ⷠThe red light indicator will blink rapidly for three seconds if the device you have selected has no Volume / Mute control. ⷠAll other devices will now use the Volume / Mute buttons of the selected device. ⷠThe selected device will now use its own Volume / Mute control. The equivalent button functions can be found on your Philips remote control. 1 Turn on the device by pressing the corresponding Mode button for more than 1 second. This method can be applied similarly to any device and is available for all device modes. For example, if your combo device is a TV / DVD then its original remote control might have separate TV and DVD buttons for selection of the combo part you wish to operate. The equivalent button functions can be found on your Philips remote control by using the device Mode and SETUP buttons. This method can be applied similarly to all Combo devices (TV / DVR, TV / VCR, DVD / DVR, etc. Keep updated for future devices The learning feature allows you to `learn' the remote control functions from your original remote control. For example: you may want to use your remote control to operate the RANDOM PLAY feature from your original CD remote control. Press and hold the SETUP button until the red light indicator turns on, then release the button. Press and release the button on the SRU5108 that you wish to learn a new function (e. Point both remote controls facing each other by approximately 1 inch apart (refer to chapter 5. Press and hold the button from which you wish to learn on the original remote control (e. POWER) until the red light indicator flashes once and then remains lit. [. . . ] Try the following hints to remedy the problem: · Make sure you selected the correct device mode. The remote control does not operate some features of your product · Use the L1 and L2 buttons to learn the remote control commands that are not available. The red light indicator flashes after you program a product code · Try to program the code again or try a different code. When you have additional questions about setup, usage, advanced features, spare parts, warranty, etc. [. . . ]