User manual PHILIPS GC4880/20 AZUR PRO

[. . . ] Therefore, it is recommended to use 100% distilled or demineralized water to prolong the lifetime of your appliance. 2 Tilt the iron backwards and fill the water tank with tap water up to the maximum level. ENGLISH 7 Do not put perfume, vinegar, starch, descaling agents, ironing aids or other chemicals in the water tank. Temperature and steam setting Table 1: Warning: Do not use steam or steam boost at low temperature, as indicated in the below table. [. . . ] Acrylic, nylon, polyamide, polyester) Temperature Steam setting setting MAX ●●● ●● ●● ● / ECO ECO Steam boost Yes Yes No No No 1 Refer to Table 1 to set the temperature dial to the appropriate setting for your garment. 2 Refer to Table 1 to set the appropriate steam setting for your garment. Note: Make sure that the steam setting you select is suitable for the set ironing temperature. The temperature light goes on to indicate that the iron is heating up. 4 When the temperature light goes out, the iron has reached the correct temperature and you could start ironing. 8 ENGLISH Features Spray function -- Press the spray button to moisten the article to be ironed. -- Press and release the steam boost trigger for a powerful boost of steam to remove stubborn creases. Ironing with extra steam -- For extra steam during ironing, press and hold the steam boost trigger. Vertical steam -- You can use the steam boost function when you hold the iron in vertical position for removing creases from hanging clothes, curtains etc. 1 Make sure the iron is unplugged and the steam slider is set to dry setting. Keep pushing the calc clean button and gently shake the iron forth and back until all water in the water tank has been used up. Scales is flushed out, steam and boiling water also come out of the soleplate. Note: Repeat steps 2 to 5 if the water that comes out of the iron still contains scale particles. 10 Move the iron gently over a piece of cloth to remove any water stains on the soleplate. ENGLISH 11 Storage 1 Unplug the iron and empty the water tank. 2 Wind the mains cord around the backplate of the iron and store it on its heel. Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. €If you are unable to solve the problem with the information below, visit www. [. . . ] €If you are unable to solve the problem with the information below, visit www. Com/ support for a list of frequently asked questions or contact the Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details). Problem The steam boost function does not work properly (water leaks out of the soleplate). Possible cause You have used the steam boost function too often within a very short period. [. . . ]